When I added the block to the fdi file, my phone would be detected, however I could not get it to connect with any of the three AT&T "settings" NM displayed when I added a new Mobile Broadband Connection.
When I removed the two command_sets lines as requested I get this error in syslog upon plugging in the phone:
usb 4-2: new full speed USB device using uhci_hcd and address 3
usb 4-2: configuration #1 chosen from 1 choice
cdc_acm 4-2:1.10: ttyACM0: USB ACM device
usb 4-2: bad CDC descriptors
usb 4-2: bad CDC descriptors
NetworkManager: <debug> [1222367685.559139] probe_modem(): Couldn't get caps
and the phone is not detected
I have a working wvdial.conf for this, but how are people getting NM to make the correct settings and dial?
I'm new to playing with this.
When I added the block to the fdi file, my phone would be detected, however I could not get it to connect with any of the three AT&T "settings" NM displayed when I added a new Mobile Broadband Connection.
When I removed the two command_sets lines as requested I get this error in syslog upon plugging in the phone:
usb 4-2: new full speed USB device using uhci_hcd and address 3
usb 4-2: configuration #1 chosen from 1 choice
cdc_acm 4-2:1.10: ttyACM0: USB ACM device
usb 4-2: bad CDC descriptors
usb 4-2: bad CDC descriptors
NetworkManager: <debug> [1222367685.559139] probe_modem(): Couldn't get caps
and the phone is not detected
I have a working wvdial.conf for this, but how are people getting NM to make the correct settings and dial?