Comment 37 for bug 267297

I think I have this bug, too. I just upgraded to Interpid.
Using 1:6.9.0+git20080826.a3cc1d7a-2ubuntu3 (intrepid)
When I went from Hardy to Intrepid, I had to install the ATI driver. The flgr driver disappeared ??

When Intrepid first boots, the display flickers. It tries to display at 1900x1200 (my monitor's resolution)
Then in between flickers, I have to go into the K launcher and select the Display properties.
The resolution goes to a newer value and then everything is more or less ok.

The setting disappears after a reboot. I have to go through the process of resetting the display resolution.

hope this helps! tia!

lspci -vvnn

01:05.0 VGA compatible controller [0300]: ATI Technologies Inc Radeon HD 3200 Graphics [1002:9610]
        Subsystem: Giga-byte Technology Device [1458:d000]
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
        Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
        Latency: 0, Cache Line Size: 4 bytes
        Interrupt: pin A routed to IRQ 18
        Region 0: Memory at d0000000 (32-bit, prefetchable) [size=256M]
        Region 1: I/O ports at ee00 [size=256]
        Region 2: Memory at fdee0000 (32-bit, non-prefetchable) [size=64K]
        Region 5: Memory at fdd00000 (32-bit, non-prefetchable) [size=1M]
        Capabilities: [50] Power Management version 3
                Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-
        Capabilities: [a0] Message Signalled Interrupts: Mask- 64bit+ Queue=0/0 Enable-
                Address: 0000000000000000 Data: 0000