Comment 9 for bug 131233

it seems like NM hase srror and can't go back in normal state... to
reproduce this i tryed to connect AP two time. first time it asked a
password conectetd and _sort of_ swithced to wired network, second time
it connected and indicated "no signal" but didn't swiched to wire.

one more problem was today with NM. after boot it didn't get to connect
dhcp network... but static ip working well. so now switch button show
only wlan as choice no lan.

> # iwconfig eth1

lo no wireless extensions.

eth0 no wireless extensions.

eth1 unassociated ESSID:""
          Mode:Managed Frequency=2.457 GHz Access Point: Not-Associated
          Bit Rate:0 kb/s Tx-Power=20 dBm Sensitivity=8/0
          Retry limit:7 RTS thr:off Fragment thr:off
          Power Management:off
          Link Quality:0 Signal level:0 Noise level:0
          Rx invalid nwid:0 Rx invalid crypt:3 Rx invalid frag:0
          Tx excessive retries:0 Invalid misc:0 Missed beacon:0

irda0 no wireless extensions.

> # sudo iwlist scan

lo Interface doesn't support scanning.

eth0 Interface doesn't support scanning.

eth1 Scan completed :
          Cell 01 - Address: 00:60:B3:99:99:99
                    ESSID:"elm"
                    Protocol:IEEE 802.11bg
                    Mode:Master
                    Channel:10
                    Frequency:2.457 GHz (Channel 10)
                    Encryption key:on
                    Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 6 Mb/s; 9 Mb/s
                              11 Mb/s; 12 Mb/s; 18 Mb/s; 24 Mb/s; 36 Mb/s
                              48 Mb/s; 54 Mb/s
                    Quality=72/100 Signal level=-48 dBm
                    IE: WPA Version 1
                        Group Cipher : WEP-40
                        Pairwise Ciphers (1) : WEP-40
                        Authentication Suites (1) : PSK
                    Extra: Last beacon: 916ms ago

irda0 Interface doesn't support scanning.