I have the same bug on a similar motherboard - Asrock j4105-itx (j4105 CPU, asmedia asm1061, realtek rtl8111h)
After the boot sequence
KUbuntu 18.04 fully updated to Nov-19-2018
Bios 4.0.0.1245 Intel GOP 13.0.1011
I doubt this is the same as the freedesktop 105549 bug since the hardware is quite different (no lspcon chip on this motherboard)
Also note that the problem only arises when a disk is connected to one of the asmedia sata ports on this motherboard. If no disk on asmedia all is good. No HDMI or DVI screen if disk on asmedia port
Windows (8.1) does not experience this issue .... BUT does not have drivers for this chip at all (Vesa only)> I don't currently have access to Windows 10
When the VGA port is connected to a screen then BOTH the vga and hdmi / dvi screens are active ie. the hdmi / dvi output is live if vga simultaneously connected ... though vga is primary
May be spurious, but fwiw, under these conditions ... The system will not power down correctly (even if both VGA and hdmi / dvi connected). Powerdown seems to stop after a message about "ata3 SError" "failed command STANDBY IMMEDIATE" and then a manual power off is required
I have the same bug on a similar motherboard - Asrock j4105-itx (j4105 CPU, asmedia asm1061, realtek rtl8111h)
After the boot sequence
KUbuntu 18.04 fully updated to Nov-19-2018
Bios 4.0.0.1245 Intel GOP 13.0.1011
I doubt this is the same as the freedesktop 105549 bug since the hardware is quite different (no lspcon chip on this motherboard)
Also note that the problem only arises when a disk is connected to one of the asmedia sata ports on this motherboard. If no disk on asmedia all is good. No HDMI or DVI screen if disk on asmedia port
Windows (8.1) does not experience this issue .... BUT does not have drivers for this chip at all (Vesa only)> I don't currently have access to Windows 10
When the VGA port is connected to a screen then BOTH the vga and hdmi / dvi screens are active ie. the hdmi / dvi output is live if vga simultaneously connected ... though vga is primary
May be spurious, but fwiw, under these conditions ... The system will not power down correctly (even if both VGA and hdmi / dvi connected). Powerdown seems to stop after a message about "ata3 SError" "failed command STANDBY IMMEDIATE" and then a manual power off is required
Any debug data I can provide ?