Comment 32 for bug 1366538

Revision history for this message
jmp (jmp-v) wrote :

I use a Maxtor OneTouch 250GB, and can confirm the previous reports:
even an fsck that returns "clean" (ext3 partition inside) is followed by 2 errors like:

end_request: critical target error, dev sdX, sector 0

Any subsequent fsck turns off the journal and finds many previously non existent errors.
All consistent with the diagnose and explanations given (see dmesg log below).

(Can't run smartmontools nor hdparm, "unsupported USB bridge").

Tried with all trusty linux-image updates since 3.13.0-35, even linux-image-generic-lts-utopic
(3.16.0.31.24) . All have this bug.

Reinstalled 3.13.0-34 just to be able to use this drive. It's really unfortunate that kernel maintainers refuse to fix this; seems my Ubuntus are stuck with this version 3.13.0-34 then.

Relevant dmesg:

[ 935.744030] usb 1-2: new high-speed USB device number 3 using ehci-pci
[ 935.876881] usb 1-2: New USB device found, idVendor=0d49, idProduct=7010
[ 935.876885] usb 1-2: New USB device strings: Mfr=1, Product=3, SerialNumber=2
[ 935.876888] usb 1-2: Product: OneTouch
[ 935.876890] usb 1-2: Manufacturer: Maxtor
[ 935.876893] usb 1-2: SerialNumber: Y61JF0XE
[ 935.943600] usbcore: registered new interface driver usb-storage
[ 935.958880] usbcore: registered new interface driver uas
[ 935.960525] ums-onetouch 1-2:1.0: USB Mass Storage device detected
[ 935.960754] input: Maxtor OneTouch as /devices/pci0000:00/0000:00:1a.7/usb1/1-2/input/input11
[ 935.961336] scsi6 : usb-storage 1-2:1.0
[ 935.961819] usbcore: registered new interface driver ums-onetouch
[ 937.166087] scsi 6:0:0:0: Direct-Access Maxtor OneTouch 0200 PQ: 0 ANSI: 0 CCS
[ 937.168548] sd 6:0:0:0: Attached scsi generic sg3 type 0
[ 937.169183] sd 6:0:0:0: [sdc] 490232832 512-byte logical blocks: (250 GB/233 GiB)
[ 937.375463] sd 6:0:0:0: [sdc] Write Protect is off
[ 937.375468] sd 6:0:0:0: [sdc] Mode Sense: 1c 00 00 00
[ 937.581825] sd 6:0:0:0: [sdc] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
[ 938.025841] sdc: sdc1
[ 938.469132] sd 6:0:0:0: [sdc] Attached SCSI disk
[ 1060.257726] end_request: critical target error, dev sdc, sector 0
[ 1060.260096] end_request: critical target error, dev sdc, sector 0
[ 1091.387256] usb 1-2: USB disconnect, device number 3
[ 1091.387810] sd 6:0:0:0: [sdc] Synchronizing SCSI cache
[ 1091.387842] sd 6:0:0:0: [sdc]
[ 1091.387845] Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK