At the beginning all was good, then after some times, these blocks started and now the card isn't usable AT ALL!!!
I mean, the wireless interface doesn't associate!
This is my dmesg output:
[ 24.744000] iwl4965: Intel(R) Wireless WiFi Link 4965AGN driver for Linux, 1.1.0
[ 24.744000] iwl4965: Copyright(c) 2003-2007 Intel Corporation
[ 24.744000] iwl4965: Detected Intel Wireless WiFi Link 4965AGN
[ 25.372000] iwl4965: Tunable channels: 13 802.11bg, 19 802.11a channels
[ 25.372000] wmaster0: Selected rate control algorithm 'iwl-4965-rs'
[ 46.320000] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 118.156000] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 140.904000] ADDRCONF(NETDEV_UP): wlan0: link is not ready
And this is iwconfig:
wlan0 IEEE 802.11g ESSID:"Access Point" Mode:Managed Frequency:2.437 GHz Access Point: Not-Associated
Retry min limit:7 RTS thr:off Fragment thr=2346 B
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
I only can use a wired connection... I use wicd to control the interface, but I think this shouldn't matter, since using command line doesn't solve!
At the beginning all was good, then after some times, these blocks started and now the card isn't usable AT ALL!!!
I mean, the wireless interface doesn't associate!
This is my dmesg output: NETDEV_ UP): wlan0: link is not ready NETDEV_ UP): wlan0: link is not ready NETDEV_ UP): wlan0: link is not ready
[ 24.744000] iwl4965: Intel(R) Wireless WiFi Link 4965AGN driver for Linux, 1.1.0
[ 24.744000] iwl4965: Copyright(c) 2003-2007 Intel Corporation
[ 24.744000] iwl4965: Detected Intel Wireless WiFi Link 4965AGN
[ 25.372000] iwl4965: Tunable channels: 13 802.11bg, 19 802.11a channels
[ 25.372000] wmaster0: Selected rate control algorithm 'iwl-4965-rs'
[ 46.320000] ADDRCONF(
[ 118.156000] ADDRCONF(
[ 140.904000] ADDRCONF(
And this is iwconfig:
Mode: Managed Frequency:2.437 GHz Access Point: Not-Associated
wlan0 IEEE 802.11g ESSID:"Access Point"
Retry min limit:7 RTS thr:off Fragment thr=2346 B
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
I only can use a wired connection... I use wicd to control the interface, but I think this shouldn't matter, since using command line doesn't solve!