I've had no problems using bcm43xx (granted, with 11Mbps rate) in Fiesty. The driver loads just fine after upgrade to Gutsy, but is unable to find any ESSIDs. Wrote a post in http://ubuntuforums.org/showthread.php?p=3493272.
Linux longisland 2.6.22-13-generic #1 SMP Thu Oct 4 17:52:26 GMT 2007 x86_64 GNU/Linux
I've had no problems using bcm43xx (granted, with 11Mbps rate) in Fiesty. The driver loads just fine after upgrade to Gutsy, but is unable to find any ESSIDs. Wrote a post in http:// ubuntuforums. org/showthread. php?p=3493272.
Linux longisland 2.6.22-13-generic #1 SMP Thu Oct 4 17:52:26 GMT 2007 x86_64 GNU/Linux
~$ sudo iwlist eth0 scan
eth0 No scan results
0b:00.0 Network controller [0280]: Broadcom Corporation BCM94311MCG wlan mini-PCI [14e4:4311] (rev 01)
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=375mA PME(D0- ,D1-,D2- ,D3hot- ,D3cold- )
Status: D0 PME-Enable- DSel=0 DScale=2 PME-
Capabilities: [58] Message Signalled Interrupts: Mask- 64bit- Queue=0/0 Enable-
Address: 00000000 Data: 0000
Capabilities: [d0] Express Legacy Endpoint IRQ 0
Device: Supported: MaxPayload 128 bytes, PhantFunc 0, ExtTag+
Device: Latency L0s <4us, L1 unlimited
Device: AtnBtn- AtnInd- PwrInd-
Device: Errors: Correctable- Non-Fatal- Fatal- Unsupported-
Device: RlxdOrd- ExtTag- PhantFunc- AuxPwr- NoSnoop-
Device: MaxPayload 128 bytes, MaxReadReq 128 bytes
Link: Supported Speed 2.5Gb/s, Width x1, ASPM L0s, Port 0
Link: Latency L0s <4us, L1 <64us
Link: ASPM L0s Enabled RCB 64 bytes CommClk+ ExtSynch-
Link: Speed 2.5Gb/s, Width x1
Subsystem: Dell Unknown device [1028:0007]
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 0, Cache Line Size: 64 bytes
Interrupt: pin A routed to IRQ 16
Region 0: Memory at efcfc000 (32-bit, non-prefetchable) [size=16K]