Bus 004 Device 002: ID 08ff:2810 AuthenTec, Inc. AES2810
in a Lenovo X200.
The reader works in Windows10 without problems.
$ fprintd-enroll
Using device /net/reactivated/Fprint/Device/0
Enrolling right-index-finger finger.
Enroll result: enroll-unknown-error ## this is independent from me rolling the finger
VerifyStop failed: Did not receive a reply. Possible causes include: the remote application did not send a reply, the message bus security policy blocked the reply, the reply timeout expired, or the network connection was broken.
$fprint_demo
Neither works, but displays the chip and says it uses AES2550 driver.
If I run the same with sudo gives me the same result.
If somebody could confirm this still working / not working anymore with AES2810, I would appreciate that very much!
Hi there,
can somebody confirm this working in 14.04 or newer?
I installed
sudo apt-get install libfprint0 fprint-demo libpam-fprintd gksu-polkit
from the ppa ppa:fingerprint /fprint.
My lsusb confirms the AES2810:
Bus 004 Device 002: ID 08ff:2810 AuthenTec, Inc. AES2810
in a Lenovo X200.
The reader works in Windows10 without problems.
$ fprintd-enroll d/Fprint/ Device/ 0 unknown- error ## this is independent from me rolling the finger
Using device /net/reactivate
Enrolling right-index-finger finger.
Enroll result: enroll-
VerifyStop failed: Did not receive a reply. Possible causes include: the remote application did not send a reply, the message bus security policy blocked the reply, the reply timeout expired, or the network connection was broken.
$fprint_demo
Neither works, but displays the chip and says it uses AES2550 driver.
If I run the same with sudo gives me the same result.
If somebody could confirm this still working / not working anymore with AES2810, I would appreciate that very much!