I tried this setting, I saw a small difference on the bottom which is always cut off. The higher the value of HPMechOffset, the smaller is the part cut off but even, if I set it to much higher values (I tried 1000) there is still a part cut off. It seems to work only in a limited range.
Hello Till,
I tried this setting, I saw a small difference on the bottom which is always cut off. The higher the value of HPMechOffset, the smaller is the part cut off but even, if I set it to much higher values (I tried 1000) there is still a part cut off. It seems to work only in a limited range.
Best Regards,
Jörg