Ok, so I was looking for an option like that but could not find it in any documentation. Just to add I was printing .ps targets from Argyll's targen / printarg / chartread / colprof workflow with:
lp target.ps
I did some more test prints and have attached the results again.
The -o cm-calibration=1 option does seem to turn off calibration from "Device Colour Profiles" but the "color correction setting" in CUPS still has an effect on print output, quite noticeable on a couple of targets which go from orange to purple.
I am going to create two profiles from targets printed with the -o cm-calibration=1 option with:
a). Device Colour Profiles cms ON and a profile loaded, but Cups colour correction set to High Accuracy.
b). Device Colour Profiles cms ON and a profile loaded, but Cups colour correction set to Uncorrected.
Hopefully I will then be able to asses the best way forward.
Ok, so I was looking for an option like that but could not find it in any documentation. Just to add I was printing .ps targets from Argyll's targen / printarg / chartread / colprof workflow with:
lp target.ps
I did some more test prints and have attached the results again.
The -o cm-calibration=1 option does seem to turn off calibration from "Device Colour Profiles" but the "color correction setting" in CUPS still has an effect on print output, quite noticeable on a couple of targets which go from orange to purple.
I am going to create two profiles from targets printed with the -o cm-calibration=1 option with:
a). Device Colour Profiles cms ON and a profile loaded, but Cups colour correction set to High Accuracy.
b). Device Colour Profiles cms ON and a profile loaded, but Cups colour correction set to Uncorrected.
Hopefully I will then be able to asses the best way forward.