This is not a new requirement for simplex - the kickstarts for installing the initial controller have always had these additional postinstall steps built in. If you are using the net_*.cfg files for initial installation of controller-0, whether it's standard or AIO, it's an invalid method. Having a manual step post-install to account for this workaround is not appropriate, because we could easily end up adding additional steps that are only for this initial controller installation and then your install method is broken again. If your intent is to use a network boot for the install, then I would highly recommend that you look at using pxeboot_setup.sh for setting up the boot source. You need to install using the correct kickstart files.
This is not a new requirement for simplex - the kickstarts for installing the initial controller have always had these additional postinstall steps built in. If you are using the net_*.cfg files for initial installation of controller-0, whether it's standard or AIO, it's an invalid method. Having a manual step post-install to account for this workaround is not appropriate, because we could easily end up adding additional steps that are only for this initial controller installation and then your install method is broken again. If your intent is to use a network boot for the install, then I would highly recommend that you look at using pxeboot_setup.sh for setting up the boot source. You need to install using the correct kickstart files.