F0 in GUI has wrong status

[Bernhard Baptist]

Hi

you set this bugreport to invalid: https://bugs.launchpad.net/rocrail/+bug/331832

but it isnt.

You can even check with default trackplan delivered with rocrail.

1.) Switch F0 in GUI to OFF. -> FO in GUI goes green, Light=Off is sent to loco
2.) Switch Auomatik to On
3.) F0 in GUI changes automatically to red, (WHY???) but looc still gets light=off commands.

- You say ist normal that light flag in loco config dialog follows F0 Gui button.
OK, but then it is useless and should be removed in order to avoid confusion.

checked with rev 154 and DDX

best rgds
bb

[Rocrail (r.j.versluis)]

See comment revno 186.

[Medel (mario-edelmann)]

There is always a mistake.
When I select a loco (light off) in the loco dialog, set it in a block and switch the automatic on, the light in the Rocview turns on (Point 2. and 3.).
When I changes the velocity the light at loco turn on, too
The same is when the loco is select (automatic on, light off) and I set it in a block or
when the loco is select (automatic on, set in a Block, light off,) and starts it or at an Event (Enter,IN).

Revision 188

[Rocrail (r.j.versluis)]

Is this a DDX related problem?
Can you do the same test using the virtual CS.

[Medel (mario-edelmann)]

It's with the virtual CS, too

[Medel (mario-edelmann)]

It's only at the loco if it selected

[Medel (mario-edelmann)]

I have add a tracefile with comment (in german), maybe it helps to find the mistake.

[Rocrail (r.j.versluis)]

revno 218