Clearance between traces, increase from default?
Bug #1517473 reported by
Nicklas Karlsson
This bug affects 1 person
Affects | Status | Importance | Assigned to | Milestone | |
---|---|---|---|---|---|
pcb |
Invalid
|
Undecided
|
Unassigned |
Bug Description
Clearance between two traces and shown while drawing are wrong. Clearance between copper and trace is however correct.
I expected same clearance value between traces, shown while drawing and copper although values are different.
It only seems to happen then value is increased from default, there seems to some kind of lag. It should be very easy to see the difference if "Cross hair show DRC clearance"/"Auto enforce DRC clearance" is turned on, clearance increased to substantially and drawing a trace adjacent to another inside a copper area.
To post a comment you must log in.
I don't think this is a bug...
The clearance width in polygons is a separate value to the min-copper-spacing DRC rule.
The yellow line you get when drawing traces with "Crosshair shows DRC clearance" enabled, is the DRC rule for min-spacing. The clearance width in polygons is set explicitly in the Route Styles