This wouldn't be so bad if this could only result from powering up the node by mistake in a state where it should not be powered on. It's unfortunately much worse than that:
a) I've seen my NUCs reboot instead of being powered off at the end of the commissioning cycle. The nodes were then ready and I hit this bug.
b) once the node is stuck with the "APM not present" message it's not responding to "amttool poweroff"; you need to either manually power off the node or use 'amttool reset' before using 'amttool poweroff'. This means that getting out of this situation is not trivial.
This wouldn't be so bad if this could only result from powering up the node by mistake in a state where it should not be powered on. It's unfortunately much worse than that:
a) I've seen my NUCs reboot instead of being powered off at the end of the commissioning cycle. The nodes were then ready and I hit this bug.
b) once the node is stuck with the "APM not present" message it's not responding to "amttool poweroff"; you need to either manually power off the node or use 'amttool reset' before using 'amttool poweroff'. This means that getting out of this situation is not trivial.