@Nick, I think a pretty good way of getting around this would be to allow traces going further than the clearance if the end of the trace is at a pad with the same netname.. It could maybe be enough to only allow traces going of the the outline, but not in again. If the traces goes out of the edge cut clearance it could be for a castellated pad, if it wasn't it would return an unconnected error.. Any thoughts on this?
@Nick, I think a pretty good way of getting around this would be to allow traces going further than the clearance if the end of the trace is at a pad with the same netname.. It could maybe be enough to only allow traces going of the the outline, but not in again. If the traces goes out of the edge cut clearance it could be for a castellated pad, if it wasn't it would return an unconnected error.. Any thoughts on this?