2015-09-15 19:46:57 |
Justin Partain |
description |
I know there is some geometry work being done down the road, so this may not even count as a bug per se, but here it is just in case.
I've imported a .dxf board outline into EdgeCuts layer which is relatively complex, with the sides of the PCB being on a radius. I noticed while dimensioning the board that the curves in OpenGL mode cut off pretty badly: I've attached a snip comparing legacy, OpenGL, and Cairo rendering modes. |
I know there is some geometry work being done down the road, so this may not even count as a bug per se, but here it is just in case.
I've imported a .dxf board outline into EdgeCuts layer which is relatively complex, with the sides of the PCB being on a radius. I noticed while dimensioning the board that the curves in OpenGL mode cut off pretty badly: I've attached a snip comparing legacy, OpenGL, and Cairo rendering modes.
Note: this doesn't affect gerber output in any way. Gerbers are fine, so this is just a rendering issue. BZR 6170, Windows. |
|