Pcbnew OpenGL Curve Rendering
Bug #1496114 reported by
Justin Partain
This bug affects 2 people
Affects | Status | Importance | Assigned to | Milestone | |
---|---|---|---|---|---|
KiCad |
Fix Released
|
Low
|
Maciej Suminski |
Bug Description
I know there is some geometry work being done down the road, so this may not even count as a bug per se, but here it is just in case.
I've imported a .dxf board outline into EdgeCuts layer which is relatively complex, with the sides of the PCB being on a radius. I noticed while dimensioning the board that the curves in OpenGL mode cut off pretty badly: I've attached a snip comparing legacy, OpenGL, and Cairo rendering modes.
Note: this doesn't affect gerber output in any way. Gerbers are fine, so this is just a rendering issue. BZR 6170, Windows.
tags: | added: cern gal opengl |
Changed in kicad: | |
status: | New → Confirmed |
Changed in kicad: | |
status: | Fix Committed → Fix Released |
To post a comment you must log in.
Fixed in revision 11f8e53e278038f 92bb14ea0c728e8 056497107d /git.launchpad. net/kicad/ patch/? id=11f8e53e2780 38f92bb14ea0c72 8e8056497107d
https:/