Ok, well good to know there are people developing Kicad, anyway. So far i think its pretty good.
I read though all the comments in here and it didn't help me much.
My work-around was to just make a file and fill it with the following code.
Now you have a lib with just one part, which is a hole.
Add your modules to this lib. Later on you can edit the file and delete the hole part of the module.
Let us know if it works for you.
PCBNEW-LibModule-V1 Tue 13 Nov 2012 07:16:15 PM CET
# encoding utf-8
Units mm
$INDEX
hole
$EndINDEX
$MODULE hole
Po 0 0 0 15 50A28E6A 00000000 ~~
Li hole
Sc 0
AR
Op 0 0 0
T0 0 0 1 1 0 0.15 N V 21 N "hole"
T1 0 0 1 1 0 0.15 N V 21 N "VAL**"
$PAD
Sh "1" C 8.1 8.1 0 0 0
Dr 8 0 0
At STD N 00E0FFFF
Ne 0 ""
Po 0 0
$EndPAD
$EndMODULE hole
$EndLIBRARY
Ok, well good to know there are people developing Kicad, anyway. So far i think its pretty good.
I read though all the comments in here and it didn't help me much.
My work-around was to just make a file and fill it with the following code.
Now you have a lib with just one part, which is a hole.
Add your modules to this lib. Later on you can edit the file and delete the hole part of the module.
Let us know if it works for you.
PCBNEW-LibModule-V1 Tue 13 Nov 2012 07:16:15 PM CET
# encoding utf-8
Units mm
$INDEX
hole
$EndINDEX
$MODULE hole
Po 0 0 0 15 50A28E6A 00000000 ~~
Li hole
Sc 0
AR
Op 0 0 0
T0 0 0 1 1 0 0.15 N V 21 N "hole"
T1 0 0 1 1 0 0.15 N V 21 N "VAL**"
$PAD
Sh "1" C 8.1 8.1 0 0 0
Dr 8 0 0
At STD N 00E0FFFF
Ne 0 ""
Po 0 0
$EndPAD
$EndMODULE hole
$EndLIBRARY