Comment 4 for bug 1942839

When a USB drive is inserted, dmesg shows corresponding messages as below (an example on my computer):

[187654.189048] usb 2-1: new SuperSpeed Gen 1 USB device number 2 using xhci_hcd
[187654.215104] usb 2-1: New USB device found, idVendor=125f, idProduct=312b, bcdDevice=11.00
[187654.215118] usb 2-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[187654.215124] usb 2-1: Product: ADATA USB Flash Drive
[187654.215129] usb 2-1: Manufacturer: ADATA
[187654.215133] usb 2-1: SerialNumber: 1471010191240006
[187654.222531] usb-storage 2-1:1.0: USB Mass Storage device detected
[187654.223284] scsi host4: usb-storage 2-1:1.0
[187655.395986] scsi 4:0:0:0: Direct-Access ADATA USB Flash Drive 1100 PQ: 0 ANSI: 6
[187655.396263] sd 4:0:0:0: Attached scsi generic sg1 type 0
[187655.397184] sd 4:0:0:0: [sdb] 60620800 512-byte logical blocks: (31.0 GB/28.9 GiB)
[187655.397819] sd 4:0:0:0: [sdb] Write Protect is off
[187655.397822] sd 4:0:0:0: [sdb] Mode Sense: 43 00 00 00
[187655.398398] sd 4:0:0:0: [sdb] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
[187655.435760] sdb: sdb1
[187655.438211] sd 4:0:0:0: [sdb] Attached SCSI removable disk