Comment 18 for bug 1928387

Hi @sachinmokashi,

I got a new EHL hardware (rev 201).

One of the ethernet ports can work. (On the Top-Left port)
I tried to check the other two ports by "ifconfig -a", dmesg, and lspci [1], but they were still unavailable.

Is this behavior expected? (Only one ethernet port works)

---
lspci:

00:1d.1 Ethernet controller [0200]: Intel Corporation Device [8086:4ba0] (rev 11) (prog-if 18)
        Subsystem: Intel Corporation Device [8086:7270]
        Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx+
        Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
        Latency: 0
        Interrupt: pin A routed to IRQ 128
        Region 0: Memory at 6001300000 (64-bit, non-prefetchable) [size=256K]
        Capabilities: [80] Power Management version 3
                Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0+,D1-,D2-,D3hot+,D3cold-)
                Status: D0 NoSoftRst+ PME-Enable- DSel=0 DScale=0 PME-
        Capabilities: [90] Vendor Specific Information: Len=14 <?>
        Capabilities: [d0] MSI: Enable+ Count=32/32 Maskable+ 64bit+
                Address: 00000000fee00418 Data: 0000
                Masking: c3ff0000 Pending: 00000000
        Kernel driver in use: intel-eth-pci
        Kernel modules: dwmac_intel