Comment 27 for bug 329898

Revision history for this message
RussianNeuroMancer (russianneuromancer) wrote : Re: The HP 1018 printer is not supported in Ubuntu 8.10, 9.10. In 10.04 supported but not work "out of the box".

~$ ifconfig
eth0 Link encap:Ethernet HWaddr 00:16:36:a7:ca:4a
          inet addr:192.168.1.2 Bcast:192.168.1.255 Mask:255.255.255.0
          inet6 addr: fe80::216:36ff:fea7:ca4a/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
          RX packets:5543 errors:0 dropped:0 overruns:0 frame:0
          TX packets:4998 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:5056117 (5.0 MB) TX bytes:778328 (778.3 KB)
          Interrupt:18

lo Link encap:Локальная петля (Loopback)
          inet addr:127.0.0.1 Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING MTU:16436 Metric:1
          RX packets:286 errors:0 dropped:0 overruns:0 frame:0
          TX packets:286 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:23482 (23.4 KB) TX bytes:23482 (23.4 KB)

wlan0 Link encap:Ethernet HWaddr 00:17:c4:03:51:2f
          UP BROADCAST MULTICAST MTU:1500 Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)

~$ route
Таблица маршутизации ядра протокола IP
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.1.0 * 255.255.255.0 U 1 0 0 eth0
link-local * 255.255.0.0 U 1000 0 0 eth0
default dsldevice.domai 0.0.0.0 UG 0 0 0 eth0