--
You received this bug notification because you are a member of HP Linux
Imaging and Printing, which is subscribed to HPLIP.
Matching subscriptions: HP Linux Imaging and Printing, HP Linux Imaging and Printing, HP Linux Imaging and Printing, HPLIP https://bugs.launchpad.net/bugs/1426110
Title:
HPlip-3.15.2 make error
Status in HP Linux Imaging and Printing:
New
Bug description:
I did a manual install of the hplip-3.15.2.tar on a raspberryPi 2, but
running make produces the following:
pi@raspberrypi ~/Desktop/source/hplip-3.15.2.tar/hplip-3.15.2 $ make
make: *** No targets specified and no makefile found. Stop.
pi@raspberrypi ~/Desktop/source/hplip-3.15.2.tar/hplip-3.15.2 $
I also tried hplip-3.15.2.run but that failed to find PY3.
Now run command 'make'.
And next 'sudo make install'.
Run command 'hp-setup' to configure the device.
-------- Original message --------
From: peter mason <email address hidden>
Date: 08/03/2015 10:06 PM (GMT+05:30)
To: <email address hidden>
Subject: [Bug 1426110] Re: HPlip-3.15.2 make error
config.status: creating Makefile desktop com.hp. hplip.service hplip-3. 15.2 $
config.status: creating hplip.conf
config.status: creating hplip.desktop
config.status: creating hplip-systray.
config.status: creating prnt/drv/hpijs.drv
config.status: creating prnt/drv/hpcups.drv
config.status: creating hplip.list
config.status: creating data/policykit/
config.status: executing depfiles commands
config.status: executing libtool commands
pi@raspberrypi ~/Desktop/
I have forgotten what happens next. Install?
-- /bugs.launchpad .net/bugs/ 1426110
You received this bug notification because you are a member of HP Linux
Imaging and Printing, which is subscribed to HPLIP.
Matching subscriptions: HP Linux Imaging and Printing, HP Linux Imaging and Printing, HP Linux Imaging and Printing, HPLIP
https:/
Title:
HPlip-3.15.2 make error
Status in HP Linux Imaging and Printing:
New
Bug description:
I did a manual install of the hplip-3.15.2.tar on a raspberryPi 2, but
running make produces the following:
pi@raspberrypi ~/Desktop/ source/ hplip-3. 15.2.tar/ hplip-3. 15.2 $ make source/ hplip-3. 15.2.tar/ hplip-3. 15.2 $
make: *** No targets specified and no makefile found. Stop.
pi@raspberrypi ~/Desktop/
I also tried hplip-3.15.2.run but that failed to find PY3.
Is it possible to install this software on RPi2?
To manage notifications about this bug go to: /bugs.launchpad .net/hplip/ +bug/1426110/ +subscriptions
https:/