Comment 6 for bug 1048817

Ethtool information for the NIC in my T110ii, which has so far *not* given me any problems:

Settings for eth0:
 Supported ports: [ TP ]
 Supported link modes: 10baseT/Half 10baseT/Full
                         100baseT/Half 100baseT/Full
                         1000baseT/Half 1000baseT/Full
 Supported pause frame use: No
 Supports auto-negotiation: Yes
 Advertised link modes: 10baseT/Half 10baseT/Full
                         100baseT/Half 100baseT/Full
                         1000baseT/Half 1000baseT/Full
 Advertised pause frame use: Symmetric
 Advertised auto-negotiation: Yes
 Speed: 1000Mb/s
 Duplex: Full
 Port: Twisted Pair
 PHYAD: 1
 Transceiver: internal
 Auto-negotiation: on
 MDI-X: Unknown
 Supports Wake-on: g
 Wake-on: d
 Current message level: 0x000000ff (255)
          drv probe link timer ifdown ifup rx_err tx_err
 Link detected: yes

driver: tg3
version: 3.121
firmware-version: 7.2.14 bc 5722-v3.11
bus-info: 0000:02:00.0
supports-statistics: yes
supports-test: yes
supports-eeprom-access: yes
supports-register-dump: yes