AVerMedia AverTV DVB-T USB 2.0 doesn't work on jaunty
Affects | Status | Importance | Assigned to | Milestone | |
---|---|---|---|---|---|
Ubuntu |
New
|
Undecided
|
Unassigned |
Bug Description
AVerMedia AverTV DVB-T USB 2.0 (A800) doesn't work on ubuntu jaunty, with 2.6.28-11-generic kernel. When the usb card is plugged , dmesg shows:
[32040.390466] dvb-usb: found a 'AVerMedia AverTV DVB-T USB 2.0 (A800)' in cold state, will try to load a firmware
[32040.390474] usb 2-1: firmware: requesting dvb-usb-
[32040.430261] dvb-usb: downloading firmware from file 'dvb-usb-
[32040.502992] usb 2-1: USB disconnect, address 19
[32040.505642] dvb-usb: generic DVB-USB module successfully deinitialized and disconnected.
[32042.256133] usb 2-1: new high speed USB device using ehci_hcd and address 20
[32042.389724] usb 2-1: configuration #1 chosen from 1 choice
[32042.390269] dvb-usb: found a 'AVerMedia AverTV DVB-T USB 2.0 (A800)' in warm state.
[32042.390334] dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer.
[32042.390506] DVB: registering new adapter (AVerMedia AverTV DVB-T USB 2.0 (A800))
[32042.394796] dvb-usb: recv bulk message failed: -71
[32042.438300] dvb-usb: bulk message failed: -71 (6/0)
[32042.438502] dvb-usb: no frontend was attached by 'AVerMedia AverTV DVB-T USB 2.0 (A800)'
[32042.444135] input: IR-receiver inside an USB DVB receiver as /devices/
[32042.504239] dvb-usb: schedule remote query interval to 150 msecs.
[32042.504245] dvb-usb: AVerMedia AverTV DVB-T USB 2.0 (A800) successfully initialized and connected.
[32042.656252] dvb-usb: error while querying for an remote control event.
[32042.809244] dvb-usb: error while querying for an remote control event.
[32042.840737] usb 2-1: USB disconnect, address 20
[32042.855752] dvb-usb: AVerMedia AverTV DVB-T USB 2.0 (A800) successfully deinitialized and disconnected.
[32043.092192] usb 2-1: new high speed USB device using ehci_hcd and address 21
lsusb -v command shows:
Bus 002 Device 013: ID 07ca:a801 AVerMedia Technologies, Inc.
Device Descriptor:
bLength 18
bDescriptorType 1
bcdUSB 2.00
bDeviceClass 0 (Defined at Interface level)
bDeviceSubClass 0
bDeviceProtocol 0
bMaxPacketSize0 64
idVendor 0x07ca AVerMedia Technologies, Inc.
idProduct 0xa801
bcdDevice 0.00
iManufacturer 1
iProduct 2
iSerial 0
bNumConfigura
Configuration Descriptor:
bLength 9
bDescriptorType 2
wTotalLength 46
bNumInterfaces 1
bConfigurat
iConfiguration 0
bmAttributes 0x80
(Bus Powered)
MaxPower 500mA
Interface Descriptor:
bLength 9
bDescript
bInterfac
bAlternat
bNumEndpoints 4
bInterfac
bInterfac
bInterfac
iInterface 0
Endpoint Descriptor:
bLength 7
Transfer Type Bulk
Synch Type None
Usage Type Data
bInterval 0
Endpoint Descriptor:
bLength 7
Transfer Type Bulk
Synch Type None
Usage Type Data
bInterval 0
Endpoint Descriptor:
bLength 7
Transfer Type Bulk
Synch Type None
Usage Type Data
bInterval 0
Endpoint Descriptor:
bLength 7
Transfer Type Bulk
Synch Type None
Usage Type Data
bInterval 0
Thanks.
but its not a duplicate problem not only is it a different card the symptons
are different as in not the same
On Sat, May 23, 2009 at 12:21 AM, Teej <email address hidden> wrote:
> *** This bug is a duplicate of bug 229879 *** /bugs.launchpad .net/bugs/ 229879 /bugs.launchpad .net/bugs/ 377365
> https:/
>
> ** This bug has been marked a duplicate of bug 229879
> My DVB-card is flooding the consol with "recv bulk message failed"
>
> --
> AVerMedia AverTV DVB-T USB 2.0 doesn't work on jaunty
> https:/
> You received this bug notification because you are a direct subscriber
> of the bug (via bug 229879).
>