[   11.181676] vboxpci: IOMMU not found (not registered)
[   11.288925] e1000e 0000:00:19.0: irq 47 for MSI/MSI-X
[   11.392252] e1000e 0000:00:19.0: irq 47 for MSI/MSI-X
[   11.392444] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[   11.392761] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[   11.395222] iwlwifi 0000:03:00.0: L1 Enabled; Disabling L0S
[   11.395448] iwlwifi 0000:03:00.0: Radio type=0x1-0x2-0x0
[   11.578135] psmouse serio1: synaptics: Touchpad model: 1, fw: 8.0, id: 0x1e2b1, caps: 0xd001a3/0x940300/0x120c00, board id: 1611, fw id: 774180
[   11.578142] psmouse serio1: synaptics: serio: Synaptics pass-through port at isa0060/serio1/input0
[   11.627546] input: SynPS/2 Synaptics TouchPad as /devices/platform/i8042/serio1/input/input10
[   11.785187] iwlwifi 0000:03:00.0: L1 Enabled; Disabling L0S
[   11.785381] iwlwifi 0000:03:00.0: Radio type=0x1-0x2-0x0
[   12.003555] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   12.003795] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   15.065900] e1000e: eth0 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: Rx/Tx
[   15.065999] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   15.203772] psmouse serio2: alps: Unknown ALPS touchpad: E7=10 00 64, EC=10 00 64
[   19.171545] psmouse serio2: trackpoint: IBM TrackPoint firmware: 0x0e, buttons: 3/3
[   19.427663] input: TPPS/2 IBM TrackPoint as /devices/platform/i8042/serio1/serio2/input/input11
[   24.972488] IPv6: ADDRCONF(NETDEV_UP): wwan0: link is not ready
[   24.972674] IPv6: ADDRCONF(NETDEV_UP): wwan0: link is not ready
[  525.818270] usb 1-1.4: USB disconnect, device number 5