[   75.623003] cfg80211: Found new beacon on frequency: 5240 MHz (Ch 48) on phy0
[   76.290059] e1000e: eth0 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: None
[   76.290396] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   77.507954] cfg80211: Found new beacon on frequency: 5745 MHz (Ch 149) on phy0
[   77.815363] cfg80211: Found new beacon on frequency: 5805 MHz (Ch 161) on phy0
[   81.123230] wlan0: authenticate with 00:1d:73:d4:a1:04 (try 1)
[   81.126177] wlan0: authenticated
[   81.197767] wlan0: associate with 00:1d:73:d4:a1:04 (try 1)
[   81.203681] wlan0: RX AssocResp from 00:1d:73:d4:a1:04 (capab=0x431 status=0 aid=1)
[   81.203687] wlan0: associated
[   81.208513] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[   81.350713] EXT4-fs (sda6): re-mounted. Opts: errors=remount-ro,commit=0
[   81.507026] iwlagn 0000:02:00.0: Queue 2 stuck for 2000 ms.
[   81.507033] iwlagn 0000:02:00.0: On demand firmware reload
[   81.507104] ieee80211 phy0: Hardware restart was requested
[   84.500460] wlan0: deauthenticated from 00:1d:73:d4:a1:04 (Reason: 15)
[   84.507655] cfg80211: All devices are disconnected, going to restore regulatory settings
[   84.507662] cfg80211: Restoring regulatory settings
[   84.507667] cfg80211: Calling CRDA to update world regulatory domain
[   84.510545] cfg80211: Ignoring regulatory request Set by core since the driver uses its own custom regulatory domain 
[   84.510547] cfg80211: World regulatory domain updated:
[   84.510549] cfg80211:     (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[   84.510551] cfg80211:     (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   84.510552] cfg80211:     (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[   84.510554] cfg80211:     (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[   84.510555] cfg80211:     (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   84.510557] cfg80211:     (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   86.801673] eth0: no IPv6 routers present
[   87.760364] wlan0: authenticate with 00:1d:73:d4:a1:04 (try 1)
[   87.762821] wlan0: authenticated
[   87.763167] wlan0: associate with 00:1d:73:d4:a1:04 (try 1)
[   87.769150] wlan0: RX ReassocResp from 00:1d:73:d4:a1:04 (capab=0x431 status=0 aid=1)
[   87.769156] wlan0: associated
[   93.145400] init: tftpd-hpa main process (1931) terminated with status 1
[   93.145428] init: tftpd-hpa main process ended, respawning
[   99.378040] wlan0: no IPv6 routers present
[  135.641737] ipmi message handler version 39.2
[  135.649908] IPMI System Interface driver.
[  135.649946] ipmi_si: Adding default-specified kcs state machine
[  135.649948] ipmi_si: Trying default-specified kcs state machine at i/o address 0xca2, slave address 0x0, irq 0
[  135.649953] ipmi_si: Interface detection failed
[  135.663965] ipmi_si: Adding default-specified smic state machine
[  135.663973] ipmi_si: Trying default-specified smic state machine at i/o address 0xca9, slave address 0x0, irq 0
[  135.663981] ipmi_si: Interface detection failed
[  135.703891] ipmi_si: Adding default-specified bt state machine
[  135.703897] ipmi_si: Trying default-specified bt state machine at i/o address 0xe4, slave address 0x0, irq 0
[  135.703905] ipmi_si: Interface detection failed
[  135.771793] ipmi_si: Unable to find any System Interface(s)
[  136.019828] Bluetooth: RFCOMM TTY layer initialized
[  136.019834] Bluetooth: RFCOMM socket layer initialized
[  136.019836] Bluetooth: RFCOMM ver 1.11
[  136.034405] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[  136.034409] Bluetooth: BNEP filters: protocol multicast
[  136.451872] init: plymouth-stop pre-start process (2829) terminated with status 1
[  142.780340] wlan0: deauthenticating from 00:1d:73:d4:a1:04 by local choice (reason=3)
[  142.922424] cfg80211: All devices are disconnected, going to restore regulatory settings
[  142.922432] cfg80211: Restoring regulatory settings
[  142.922438] cfg80211: Calling CRDA to update world regulatory domain
[  142.925546] cfg80211: Ignoring regulatory request Set by core since the driver uses its own custom regulatory domain 
[  142.925550] cfg80211: World regulatory domain updated:
[  142.925551] cfg80211:     (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[  142.925553] cfg80211:     (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[  142.925555] cfg80211:     (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[  142.925556] cfg80211:     (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[  142.925558] cfg80211:     (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[  142.925560] cfg80211:     (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[  159.943512] [drm:intel_dp_complete_link_train] *ERROR* failed to train DP, aborting
[  796.526143] [drm:intel_dp_complete_link_train] *ERROR* failed to train DP, aborting
[  802.487163] [drm:intel_dp_complete_link_train] *ERROR* failed to train DP, aborting