[   17.082691] ath: EEPROM regdomain: 0x60
[   17.082696] ath: EEPROM indicates we should expect a direct regpair map
[   17.082700] ath: Country alpha2 being used: 00
[   17.082703] ath: Regpair used: 0x60
[   17.107579] phy0: Selected rate control algorithm 'minstrel'
[   17.108488] ath5k phy0: Atheros AR2413 chip found (MAC: 0x78, PHY: 0x45)
[   17.316580] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   17.816161] e100: eth0 NIC Link is Up 100 Mbps Full Duplex
[   17.816379] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   28.372012] eth0: no IPv6 routers present
[   85.782985] wlan0: authenticate with AP 34:ef:44:dc:cd:01
[   85.788863] wlan0: authenticated
[   85.788870] wlan0: associate with AP 34:ef:44:dc:cd:01
[   85.790766] wlan0: RX AssocResp from 34:ef:44:dc:cd:01 (capab=0x431 status=0 aid=2)
[   85.790771] wlan0: associated
[   85.791488] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[   85.846498] cfg80211: Calling CRDA for country: US
[   85.849909] cfg80211: Received country IE:
[   85.849916] cfg80211: Regulatory domain: US
[   85.849918] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[   85.849922] 	(2402000 KHz - 2477000 KHz @ 40000 KHz), (10000 mBi, 10000 mBm)
[   85.849924] cfg80211: CRDA thinks this should applied:
[   85.849926] cfg80211: Regulatory domain: US
[   85.849928] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[   85.849932] 	(2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm)
[   85.849935] 	(5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 1700 mBm)
[   85.849938] 	(5250000 KHz - 5330000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   85.849941] 	(5490000 KHz - 5710000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   85.849945] 	(5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 3000 mBm)
[   85.849947] cfg80211: We intersect both of these and get:
[   85.849949] cfg80211: Regulatory domain: 98
[   85.849951] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[   85.849954] 	(2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm)
[   85.849961] cfg80211: Disabling channel 2467 MHz on phy0 due to Country IE
[   85.849964] cfg80211: Disabling channel 2472 MHz on phy0 due to Country IE
[   85.849966] cfg80211: Disabling channel 2484 MHz on phy0 due to Country IE
[   85.849973] cfg80211: Current regulatory domain updated by AP to: US
[   85.849976] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[   85.849979] 	(2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm)
[   86.094921] padlock: VIA PadLock not detected.
[   96.156009] wlan0: no IPv6 routers present
[  131.522155] wlan0: disassociating by local choice (reason=3)