Error: command ['sh', '-c', 'dmesg | comm -13 /var/log/dmesg -'] failed with exit code 1: [ 28.676444] e1000e 0000:00:19.0: irq 30 for MSI/MSI-X [ 28.732215] e1000e 0000:00:19.0: irq 30 for MSI/MSI-X [ 28.732552] ADDRCONF(NETDEV_UP): eth0: link is not ready [ 28.733434] iwlagn 0000:03:00.0: firmware: requesting iwlwifi-4965-2.ucode [ 28.853016] iwlagn 0000:03:00.0: loaded firmware version 228.57.2.23 [ 29.053556] Registered led device: iwl-phy0::radio [ 29.053573] Registered led device: iwl-phy0::assoc [ 29.053587] Registered led device: iwl-phy0::RX [ 29.053601] Registered led device: iwl-phy0::TX [ 29.121342] ADDRCONF(NETDEV_UP): wlan0: link is not ready [ 31.511616] wlan0: authenticate with AP d6:57:37:51:67:82 [ 31.514720] wlan0: authenticated [ 31.514722] wlan0: associate with AP d6:57:37:51:67:82 [ 31.713067] wlan0: associate with AP d6:57:37:51:67:82 [ 31.912091] wlan0: associate with AP d6:57:37:51:67:82 [ 32.112087] wlan0: association with AP d6:57:37:51:67:82 timed out [ 50.088840] cfg80211: Found new beacon on frequency: 2472 MHz (Ch 13) on phy0 [ 50.088863] cfg80211: Enabling active scanning on frequency: 2472 MHz (Ch 13) on phy0 [ 50.088865] cfg80211: Enabling beaconing on frequency: 2472 MHz (Ch 13) on phy0 [ 86.839016] Bluetooth: HIDP (Human Interface Emulation) ver 1.2 [ 95.433084] wlan0: authenticate with AP d6:57:37:51:67:82 [ 97.765797] wlan0: authenticated [ 97.765806] wlan0: associate with AP d6:57:37:51:67:82 comm: file 2 is not in sorted order [ 105.103590] wlan0: authenticate with AP d6:57:37:51:67:80 [ 105.106561] wlan0: authenticated [ 105.106568] wlan0: associate with AP d6:57:37:51:67:80 [ 105.108977] wlan0: RX AssocResp from d6:57:37:51:67:80 (capab=0x411 status=0 aid=1) [ 105.108985] wlan0: associated [ 105.129903] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready [ 602.808533] geoclue-master[22941]: segfault at 0 ip 00fd4595 sp bf87e610 error 4 in libgeoclue.so.0.0.0[fd0000+e000] [ 651.896028] CE: hpet increasing min_delta_ns to 15000 nsec