Error: command ['sh', '-c', 'dmesg | comm -13 /var/log/dmesg -'] failed with exit code 1: [   40.897452] e1000e 0000:02:00.0: irq 29 for MSI/MSI-X
[   40.952197] e1000e 0000:02:00.0: irq 29 for MSI/MSI-X
[   40.952909] ADDRCONF(NETDEV_UP): eth0: link is not ready
[   40.953977] iwl3945 0000:03:00.0: firmware: requesting iwlwifi-3945-2.ucode
[   41.300709] iwl3945 0000:03:00.0: loaded firmware version 15.28.2.8
[   41.347341] Registered led device: iwl-phy0::radio
[   41.347420] Registered led device: iwl-phy0::assoc
[   41.347455] Registered led device: iwl-phy0::RX
[   41.347498] Registered led device: iwl-phy0::TX
[   41.361336] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   42.490578] e1000e: eth0 NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX
[   42.490583] 0000:02:00.0: eth0: 10/100 speed: disabling TSO
[   42.490915] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   43.576041] virbr0: no IPv6 routers present
[   52.964117] eth0: no IPv6 routers present
comm: file 2 is not in sorted order
[  166.465313] wlan0: authenticate with AP 00:19:db:08:7d:f1
[  166.467222] wlan0: authenticated
[  166.467230] wlan0: associate with AP 00:19:db:08:7d:f1
[  166.469853] wlan0: RX AssocResp from 00:19:db:08:7d:f1 (capab=0x411 status=0 aid=3)
[  166.469859] wlan0: associated
[  166.471941] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[  166.958314] padlock: VIA PadLock not detected.
[  176.844054] wlan0: no IPv6 routers present
[  260.868085] usb 2-1: new full speed USB device using uhci_hcd and address 2
[  261.021441] usb 2-1: configuration #1 chosen from 1 choice
[  261.176362] smsusb_probe: line: 416: rom interface 0 is not used
[  261.179370] usb 2-1: firmware: requesting sms1xxx-stellar-dvbt-01.fw
[  261.183807] smsusb1_load_firmware: failed to open "sms1xxx-stellar-dvbt-01.fw" mode 4, trying again with default firmware
[  261.183816] usb 2-1: firmware: requesting dvbt_bda_stellar_usb.inp
[  261.190475] smsusb1_load_firmware: failed to open "dvbt_bda_stellar_usb.inp" mode 4
[  261.190494] smsusb: probe of 2-1:1.1 failed with error -2
[  261.190535] usbcore: registered new interface driver smsusb