[ 22.653638] e1000e 0000:00:19.0: irq 41 for MSI/MSI-X [ 22.653803] ADDRCONF(NETDEV_UP): eth0: link is not ready [ 22.654224] ADDRCONF(NETDEV_UP): eth0: link is not ready [ 22.656072] iwlwifi 0000:03:00.0: L1 Enabled; Disabling L0S [ 22.656264] iwlwifi 0000:03:00.0: Radio type=0x1-0x2-0x0 [ 22.942654] iwlwifi 0000:03:00.0: L1 Enabled; Disabling L0S [ 22.942965] iwlwifi 0000:03:00.0: Radio type=0x1-0x2-0x0 [ 23.064645] ADDRCONF(NETDEV_UP): wlan0: link is not ready [ 23.064989] ADDRCONF(NETDEV_UP): wlan0: link is not ready [ 23.066925] ADDRCONF(NETDEV_UP): usb0: link is not ready [ 23.067228] ADDRCONF(NETDEV_UP): usb0: link is not ready [ 23.071101] cdc_ncm: usb0: network connection: disconnected [ 23.072837] ADDRCONF(NETDEV_UP): usb0: link is not ready [ 23.073544] ADDRCONF(NETDEV_UP): usb0: link is not ready [ 23.073754] ADDRCONF(NETDEV_UP): usb0: link is not ready [ 23.907471] cfg80211: Found new beacon on frequency: 2467 MHz (Ch 12) on phy0 [ 24.273548] IBM TrackPoint firmware: 0x0e, buttons: 3/3 [ 24.532194] input: TPPS/2 IBM TrackPoint as /devices/platform/i8042/serio1/serio2/input/input11 [ 30.145949] wlan0: authenticate with 00:23:f8:d9:ec:72 (try 1) [ 30.147705] wlan0: authenticated [ 30.185746] wlan0: associate with 00:23:f8:d9:ec:72 (try 1) [ 30.188103] wlan0: RX AssocResp from 00:23:f8:d9:ec:72 (capab=0x471 status=0 aid=5) [ 30.188113] wlan0: associated [ 30.191293] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready [ 40.591893] wlan0: no IPv6 routers present [ 52.164369] usb 1-1.1: new high-speed USB device number 5 using ehci_hcd [ 52.305916] Initializing USB Mass Storage driver... [ 52.306068] scsi6 : usb-storage 1-1.1:1.0 [ 52.306152] usbcore: registered new interface driver usb-storage [ 52.306154] USB Mass Storage support registered. [ 52.329767] usbcore: registered new interface driver uas [ 53.308716] scsi 6:0:0:0: CD-ROM HUAWEI Mass storage ffff PQ: 0 ANSI: 2 [ 53.327963] scsi 6:0:0:1: Direct-Access HUAWEI Mass storage ffff PQ: 0 ANSI: 2 [ 53.375594] sr1: scsi-1 drive [ 53.375738] sr 6:0:0:0: Attached scsi CD-ROM sr1 [ 53.375823] sr 6:0:0:0: Attached scsi generic sg2 type 5 [ 53.376393] sd 6:0:0:1: Attached scsi generic sg3 type 0 [ 53.815384] sd 6:0:0:1: [sdb] Attached SCSI removable disk [ 3383.165221] mmc0: new SDHC card at address 1349 [ 3383.191181] mmcblk0: mmc0:1349 SD04G 3.75 GiB [ 3383.192387] mmcblk0: p1 [ 6067.446588] mmc0: card 1349 removed [ 6214.022266] mmc0: new SDHC card at address 1349 [ 6214.022599] mmcblk0: mmc0:1349 SD04G 3.75 GiB [ 6214.024036] mmcblk0: p1 [ 6214.210064] mmcblk0: error -123 sending status command, retrying [ 6214.210084] mmcblk0: error -123 sending status command, retrying [ 6214.210101] mmcblk0: error -123 sending status command, aborting [ 6214.210105] end_request: I/O error, dev mmcblk0, sector 8192 [ 6214.210111] FAT-fs (mmcblk0p1): unable to read boot sector [ 6214.379555] mmc0: card 1349 removed [ 6215.877541] mmc0: new SDHC card at address 1349 [ 6215.877883] mmcblk0: mmc0:1349 SD04G 3.75 GiB [ 6215.879286] mmcblk0: p1