[   18.820972] e1000e: eth0 NIC Link is Up 100 Mbps Full Duplex, Flow Control: None
[   18.820982] e1000e 0000:00:19.0: eth0: 10/100 speed: disabling TSO
[   18.821660] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   19.712045] Bluetooth: L2CAP ver 2.14
[   19.712052] Bluetooth: L2CAP socket layer initialized
[   19.923907] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[   19.923914] Bluetooth: BNEP filters: protocol multicast
[   19.960639] Bluetooth: SCO (Voice Link) ver 0.6
[   19.960645] Bluetooth: SCO socket layer initialized
[   20.198704] Bluetooth: RFCOMM TTY layer initialized
[   20.198716] Bluetooth: RFCOMM socket layer initialized
[   20.198721] Bluetooth: RFCOMM ver 1.11
[   20.601765]   alloc irq_desc for 49 on node -1
[   20.601773]   alloc kstat_irqs on node -1
[   20.601796] fglrx_pci 0000:01:00.0: irq 49 for MSI/MSI-X
[   20.603637] [fglrx] Firegl kernel thread PID: 1473
[   20.604007] [fglrx] IRQ 49 Enabled
[   22.164233] EXT4-fs (sda2): re-mounted. Opts: errors=remount-ro,commit=0
[   22.241144] EXT4-fs (sda6): re-mounted. Opts: commit=0
[   23.033163] [fglrx] Gart USWC size:608 M.
[   23.033171] [fglrx] Gart cacheable size:238 M.
[   23.033183] [fglrx] Reserved FB block: Shared offset:0, size:1000000 
[   23.033190] [fglrx] Reserved FB block: Unshared offset:fe12000, size:1e9000 
[   23.033196] [fglrx] Reserved FB block: Unshared offset:fffb000, size:5000 
[   25.965137] [fglrx:fireglAsyncioIntEnableMsgHandler] *ERROR* interrupt source ff000066 is not supported on this hardware (return code = 1)
[   29.771504] eth0: no IPv6 routers present
[   40.505360] EXT4-fs (sda2): re-mounted. Opts: errors=remount-ro,commit=0
[   40.528290] EXT4-fs (sda6): re-mounted. Opts: commit=0
[   41.131469] cannot submit datapipe for urb 0, error -28: not enough bandwidth
[   82.097366] cannot submit datapipe for urb 0, error -28: not enough bandwidth
[  118.776834] wlan0: authenticate with 00:15:c7:80:49:61 (try 1)
[  118.780084] wlan0: authenticated
[  118.780131] wlan0: associate with 00:15:c7:80:49:61 (try 1)
[  118.783611] wlan0: RX AssocResp from 00:15:c7:80:49:61 (capab=0x421 status=0 aid=3)
[  118.783620] wlan0: associated
[  118.785870] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[  118.785978] cfg80211: Calling CRDA for country: US
[  118.797744] cfg80211: Received country IE:
[  118.797751] cfg80211: Regulatory domain: US
[  118.797755]     (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[  118.797763]     (2402000 KHz - 2472000 KHz @ 40000 KHz), (10000 mBi, 3000 mBm)
[  118.797768] cfg80211: CRDA thinks this should applied:
[  118.797772] cfg80211: Regulatory domain: US
[  118.797776]     (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[  118.797783]     (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm)
[  118.797790]     (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 1700 mBm)
[  118.797797]     (5250000 KHz - 5330000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[  118.797804]     (5490000 KHz - 5600000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[  118.797810]     (5650000 KHz - 5710000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[  118.797817]     (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 3000 mBm)
[  118.797822] cfg80211: We intersect both of these and get:
[  118.797826] cfg80211: Regulatory domain: 98
[  118.797830]     (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[  118.797836]     (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm)
[  118.797848] cfg80211: Disabling channel 2467 MHz on phy0 due to Country IE
[  118.797853] cfg80211: Disabling channel 2472 MHz on phy0 due to Country IE
[  118.797859] cfg80211: Leaving channel 5180 MHz intact on phy0 - no rule found in band on Country IE
[  118.797866] cfg80211: Leaving channel 5200 MHz intact on phy0 - no rule found in band on Country IE
[  118.797872] cfg80211: Leaving channel 5220 MHz intact on phy0 - no rule found in band on Country IE
[  118.797878] cfg80211: Leaving channel 5240 MHz intact on phy0 - no rule found in band on Country IE
[  118.797884] cfg80211: Leaving channel 5260 MHz intact on phy0 - no rule found in band on Country IE
[  118.797890] cfg80211: Leaving channel 5280 MHz intact on phy0 - no rule found in band on Country IE
[  118.797896] cfg80211: Leaving channel 5300 MHz intact on phy0 - no rule found in band on Country IE
[  118.797902] cfg80211: Leaving channel 5320 MHz intact on phy0 - no rule found in band on Country IE
[  118.797908] cfg80211: Leaving channel 5500 MHz intact on phy0 - no rule found in band on Country IE
[  118.797914] cfg80211: Leaving channel 5520 MHz intact on phy0 - no rule found in band on Country IE
[  118.797921] cfg80211: Leaving channel 5540 MHz intact on phy0 - no rule found in band on Country IE
[  118.797927] cfg80211: Leaving channel 5560 MHz intact on phy0 - no rule found in band on Country IE
[  118.797933] cfg80211: Leaving channel 5580 MHz intact on phy0 - no rule found in band on Country IE
[  118.797939] cfg80211: Leaving channel 5600 MHz intact on phy0 - no rule found in band on Country IE
[  118.797945] cfg80211: Leaving channel 5620 MHz intact on phy0 - no rule found in band on Country IE
[  118.797951] cfg80211: Leaving channel 5640 MHz intact on phy0 - no rule found in band on Country IE
[  118.797957] cfg80211: Leaving channel 5660 MHz intact on phy0 - no rule found in band on Country IE
[  118.797963] cfg80211: Leaving channel 5680 MHz intact on phy0 - no rule found in band on Country IE
[  118.797969] cfg80211: Leaving channel 5700 MHz intact on phy0 - no rule found in band on Country IE
[  118.797975] cfg80211: Leaving channel 5745 MHz intact on phy0 - no rule found in band on Country IE
[  118.797982] cfg80211: Leaving channel 5765 MHz intact on phy0 - no rule found in band on Country IE
[  118.797988] cfg80211: Leaving channel 5785 MHz intact on phy0 - no rule found in band on Country IE
[  118.797994] cfg80211: Leaving channel 5805 MHz intact on phy0 - no rule found in band on Country IE
[  118.798000] cfg80211: Leaving channel 5825 MHz intact on phy0 - no rule found in band on Country IE
[  118.798012] cfg80211: Current regulatory domain updated by AP to: US
[  118.798016]     (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[  118.798023]     (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm)
[  124.531565] process `skype' is using obsolete setsockopt SO_BSDCOMPAT
[  129.010040] wlan0: no IPv6 routers present
[  163.731432] wlan0: deauthenticating from 00:15:c7:80:49:61 by local choice (reason=3)
[  163.773998] wlan0: authenticate with 00:15:c7:80:43:01 (try 1)
[  163.776611] wlan0: authenticated
[  163.776658] wlan0: associate with 00:15:c7:80:43:01 (try 1)
[  163.781879] wlan0: RX AssocResp from 00:15:c7:80:43:01 (capab=0x421 status=0 aid=46)
[  163.781887] wlan0: associated
[  219.505508] [fglrx:fireglAsyncioIntEnableMsgHandler] *ERROR* interrupt source ff000066 is not supported on this hardware (return code = 1)
[  247.373372] CE: hpet increased min_delta_ns to 7500 nsec
[  292.690191] CE: hpet increased min_delta_ns to 11250 nsec
[  340.352741] lo: Disabled Privacy Extensions
[  343.630156] wlan0: deauthenticating from 00:15:c7:80:43:01 by local choice (reason=3)
[  343.632853] wlan0: authenticate with 00:15:c7:80:49:61 (try 1)
[  343.637710] wlan0: authenticated
[  343.668350] wlan0: associate with 00:15:c7:80:49:61 (try 1)
[  343.673151] wlan0: RX AssocResp from 00:15:c7:80:49:61 (capab=0x421 status=0 aid=5)
[  343.673160] wlan0: associated
[  351.441203] CE: hpet increased min_delta_ns to 16875 nsec
[  443.960147] wlan0: deauthenticating from 00:15:c7:80:49:61 by local choice (reason=3)
[  443.964875] wlan0: authenticate with 00:15:c7:80:43:01 (try 1)
[  443.972715] wlan0: authenticated
[  444.000700] wlan0: associate with 00:15:c7:80:43:01 (try 1)
[  444.004517] wlan0: RX AssocResp from 00:15:c7:80:43:01 (capab=0x421 status=0 aid=46)
[  444.004525] wlan0: associated