[   15.407667] phy0 -> rt2500usb_init_eeprom: Error - Invalid RT chipset detected.
[   15.407681] phy0 -> rt2x00lib_probe_dev: Error - Failed to allocate device.
[   15.407781] usbcore: registered new interface driver rt2500usb
[   16.056092] phy1: Selected rate control algorithm 'minstrel'
[   16.057543] Registered led device: rt73usb-phy1::radio
[   16.057583] Registered led device: rt73usb-phy1::assoc
[   16.057621] Registered led device: rt73usb-phy1::quality
[   16.059054] usbcore: registered new interface driver rt73usb
[   18.832816] eth0:  setting half-duplex.
[   18.832950] ADDRCONF(NETDEV_UP): eth0: link is not ready
[   18.850017] rt73usb 5-1:1.0: firmware: requesting rt73.bin
[   19.076834] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   23.053710] agpgart-intel 0000:00:00.0: AGP 2.0 bridge
[   23.053741] agpgart-intel 0000:00:00.0: putting AGP V2 device into 4x mode
[   23.053783] nvidia 0000:01:00.0: putting AGP V2 device into 4x mode
[   25.110424] usb 4-2: configuration #1 chosen from 1 choice
[   25.142705] Bluetooth: Generic Bluetooth USB driver ver 0.5
[   25.142971] usbcore: registered new interface driver btusb
[   25.425342] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[   25.425352] Bluetooth: BNEP filters: protocol multicast
[   25.446254] Bridge firewalling registered
[   28.896105] wlan0: authenticate with AP 00:1c:f0:88:1d:3c
[   28.900513] wlan0: authenticated
[   28.900525] wlan0: associate with AP 00:1c:f0:88:1d:3c
[   28.904605] wlan0: RX AssocResp from 00:1c:f0:88:1d:3c (capab=0x431 status=0 aid=2)
[   28.904615] wlan0: associated
[   28.951586] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[   39.280074] wlan0: no IPv6 routers present
[  107.636073] Clocksource tsc unstable (delta = -107097692 ns)