Error: command ['sh', '-c', 'dmesg | comm -13 /var/log/dmesg -'] failed with exit code 1: [   33.097006] tg3 0000:06:08.0: firmware: requesting tigon/tg3_tso5.bin
[   33.242081] tg3 0000:06:08.0: wake-up capability disabled by ACPI
[   33.242089] tg3 0000:06:08.0: PME# disabled
[   33.514710] ADDRCONF(NETDEV_UP): eth0: link is not ready
[   33.516366] ADDRCONF(NETDEV_UP): eth1: link is not ready
[   35.111166] tg3: eth0: Link is up at 100 Mbps, full duplex.
[   35.111171] tg3: eth0: Flow control is on for TX and on for RX.
[   35.111368] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   45.220157] eth0: no IPv6 routers present
[   50.916757] synaptics: using relaxed packet validation
[  629.452288] ipw2200 0000:06:03.0: PCI INT A disabled
[  635.884584] ipw2200: Intel(R) PRO/Wireless 2200/2915 Network Driver, 1.2.2kmprq
[  635.884588] ipw2200: Copyright(c) 2003-2006 Intel Corporation
[  635.884667] ipw2200 0000:06:03.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
[  635.884750] ipw2200: Detected Intel PRO/Wireless 2200BG Network Connection
[  635.884789] ipw2200 0000:06:03.0: firmware: requesting ipw2200-bss.fw
[  636.008735] ipw2200: Radio Frequency Kill Switch is On:
[  636.008737] Kill switch must be turned off for wireless networking to work.
[  636.020816] ipw2200: Detected geography ZZM (11 802.11bg channels, 0 802.11a channels)
[  640.100333] ADDRCONF(NETDEV_UP): eth1: link is not ready
[  665.969030] ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready
[  666.007349] lib80211_crypt: registered algorithm 'TKIP'
[  676.848167] eth1: no IPv6 routers present
comm: file 2 is not in sorted order
[ 6213.496019] ACPI: EC: missing confirmations, switch off interrupt mode.
[ 7962.549183] tg3: eth0: Link is down.