[   17.082796] init: anacron main process (1096) killed by TERM signal
[   37.193101] usb 3-3: new high-speed USB device number 2 using xhci_hcd
[   37.235450] cdc_acm 3-3:1.1: This device cannot do calls on its own. It is not a modem.
[   37.235509] cdc_acm 3-3:1.1: ttyACM0: USB ACM device
[   37.237835] usbcore: registered new interface driver cdc_acm
[   37.237838] cdc_acm: USB Abstract Control Model driver for USB modems and ISDN adapters
[   37.412546] Initializing USB Mass Storage driver...
[   37.412677] scsi7 : usb-storage 3-3:1.0
[   37.412768] usbcore: registered new interface driver usb-storage
[   37.412770] USB Mass Storage support registered.
[   38.409491] scsi 7:0:0:0: Direct-Access     SAMSUNG  S5360 Card       0000 PQ: 0 ANSI: 2
[   38.409989] sd 7:0:0:0: Attached scsi generic sg3 type 0
[   38.413054] sd 7:0:0:0: [sdc] Attached SCSI removable disk
[   69.619404] wlan0: authenticate with 18:e2:c2:b8:c7:32
[   69.642496] wlan0: send auth to 18:e2:c2:b8:c7:32 (try 1/3)
[   69.644503] wlan0: authenticated
[   69.644637] ath9k 0000:02:00.0: wlan0: disabling HT as WMM/QoS is not supported by the AP
[   69.644641] ath9k 0000:02:00.0: wlan0: disabling VHT as WMM/QoS is not supported by the AP
[   69.646731] wlan0: associate with 18:e2:c2:b8:c7:32 (try 1/3)
[   69.649515] wlan0: RX AssocResp from 18:e2:c2:b8:c7:32 (capab=0x401 status=0 aid=1)
[   69.649571] wlan0: associated
[   69.649916] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[   80.287345] wlan0: no IPv6 routers present
[  187.761267] usb 3-4: new low-speed USB device number 3 using xhci_hcd
[  187.781725] usb 3-4: ep 0x81 - rounding interval to 64 microframes, ep desc says 80 microframes
[  187.934569] input:  USB OPTICAL MOUSE as /devices/pci0000:00/0000:00:14.0/usb3/3-4/3-4:1.0/input/input11
[  187.934769] generic-usb 0003:0000:0538.0001: input,hidraw0: USB HID v1.11 Mouse [ USB OPTICAL MOUSE] on usb-0000:00:14.0-4/input0
[  187.935200] usbcore: registered new interface driver usbhid
[  187.935203] usbhid: USB HID core driver
[  188.044918] usb 3-4: USB disconnect, device number 3
[  188.409045] usb 3-4: new low-speed USB device number 4 using xhci_hcd
[  188.429445] usb 3-4: ep 0x81 - rounding interval to 64 microframes, ep desc says 80 microframes
[  188.432069] input:  USB OPTICAL MOUSE as /devices/pci0000:00/0000:00:14.0/usb3/3-4/3-4:1.0/input/input12
[  188.432540] generic-usb 0003:0000:0538.0002: input,hidraw0: USB HID v1.11 Mouse [ USB OPTICAL MOUSE] on usb-0000:00:14.0-4/input0
[ 6509.821500] dell_wmi: Unknown key e00e pressed
[15996.016145] usb 3-3: USB disconnect, device number 2
[15996.292409] usb 3-3: new high-speed USB device number 5 using xhci_hcd
[15996.311701] scsi8 : usb-storage 3-3:1.0
[15996.312223] cdc_acm 3-3:1.1: This device cannot do calls on its own. It is not a modem.
[15996.312350] cdc_acm 3-3:1.1: ttyACM0: USB ACM device
[15997.308850] scsi 8:0:0:0: Direct-Access     SAMSUNG  S5360 Card       0000 PQ: 0 ANSI: 2
[15997.310803] sd 8:0:0:0: Attached scsi generic sg3 type 0
[15997.313398] sd 8:0:0:0: [sdc] Attached SCSI removable disk
[17402.895580] wlan0: deauthenticating from 18:e2:c2:b8:c7:32 by local choice (reason=3)
[17402.902955] cfg80211: All devices are disconnected, going to restore regulatory settings
[17402.902959] cfg80211: Restoring regulatory settings
[17402.902962] cfg80211: Kicking the queue
[17402.902963] cfg80211: Calling CRDA to update world regulatory domain
[17402.909318] cfg80211: Ignoring regulatory request Set by core since the driver uses its own custom regulatory domain
[17402.912314] cfg80211: World regulatory domain updated:
[17402.912318] cfg80211:   (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[17402.912321] cfg80211:   (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[17402.912323] cfg80211:   (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[17402.912326] cfg80211:   (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[17402.912328] cfg80211:   (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[17402.912330] cfg80211:   (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[17409.443786] wlan0: authenticate with 18:e2:c2:b8:c7:32
[17409.460915] wlan0: send auth to 18:e2:c2:b8:c7:32 (try 1/3)
[17409.462954] wlan0: authenticated
[17409.463151] ath9k 0000:02:00.0: wlan0: disabling HT as WMM/QoS is not supported by the AP
[17409.463155] ath9k 0000:02:00.0: wlan0: disabling VHT as WMM/QoS is not supported by the AP
[17409.463445] wlan0: associate with 18:e2:c2:b8:c7:32 (try 1/3)
[17409.466287] wlan0: RX AssocResp from 18:e2:c2:b8:c7:32 (capab=0x401 status=0 aid=1)
[17409.466337] wlan0: associated
[17420.427954] wlan0: no IPv6 routers present
[18419.824982] usb 3-3: USB disconnect, device number 5
[18420.102585] usb 3-3: new high-speed USB device number 6 using xhci_hcd
[18420.121991] scsi9 : usb-storage 3-3:1.0
[18420.122530] cdc_acm 3-3:1.1: This device cannot do calls on its own. It is not a modem.
[18420.122629] cdc_acm 3-3:1.1: ttyACM0: USB ACM device
[18421.119051] scsi 9:0:0:0: Direct-Access     SAMSUNG  S5360 Card       0000 PQ: 0 ANSI: 2
[18421.121393] sd 9:0:0:0: Attached scsi generic sg3 type 0
[18421.123310] sd 9:0:0:0: [sdc] Attached SCSI removable disk
[19938.900363] dell_wmi: Unknown key e00e pressed