[   35.886898] init: gdm main process (1420) killed by TERM signal
[   41.791335] wlan0: authenticate with 64:68:0c:80:62:c1 (try 1)
[   41.793131] wlan0: authenticated
[   41.793235] wlan0: associate with 64:68:0c:80:62:c1 (try 1)
[   41.796459] wlan0: RX AssocResp from 64:68:0c:80:62:c1 (capab=0x411 status=0 aid=5)
[   41.796462] wlan0: associated
[   41.836208] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[   47.519176] Bluetooth: HIDP (Human Interface Emulation) ver 1.2
[   52.096029] wlan0: no IPv6 routers present
[   73.477822] iwl4965 0000:03:00.0: Aggregation not enabled for tid 0 because load = 1
[   77.138180] process `skype' is using obsolete setsockopt SO_BSDCOMPAT
[   78.928020] iwl4965 0000:03:00.0: iwl4965_tx_agg_start on ra = 64:68:0c:80:62:c1 tid = 0
[  222.010200] iwl4965 0000:03:00.0: Aggregation not enabled for tid 6 because load = 0
[  817.256054] usb 2-2: new high-speed USB device number 4 using ehci_hcd
[  817.388729] hub 2-2:1.0: USB hub found
[  817.388805] hub 2-2:1.0: 4 ports detected
[  817.676181] usb 2-2.1: new full-speed USB device number 5 using ehci_hcd
[  817.908217] usb 2-2.4: new high-speed USB device number 6 using ehci_hcd
[  818.018895] hub 2-2.4:1.0: USB hub found
[  818.019039] hub 2-2.4:1.0: 4 ports detected
[  832.960203] usb 2-2.4.4: new high-speed USB device number 7 using ehci_hcd
[  833.118276] Initializing USB Mass Storage driver...
[  833.122119] scsi5 : usb-storage 2-2.4.4:1.0
[  833.122218] usbcore: registered new interface driver usb-storage
[  833.122220] USB Mass Storage support registered.
[  833.122525] usbcore: registered new interface driver uas
[  834.120854] scsi 5:0:0:0: Direct-Access     ST364032 3AS                   PQ: 0 ANSI: 2 CCS
[  834.123401] sd 5:0:0:0: Attached scsi generic sg2 type 0
[  834.126158] sd 5:0:0:0: [sdb] 1250263728 512-byte logical blocks: (640 GB/596 GiB)
[  834.126928] sd 5:0:0:0: [sdb] Write Protect is off
[  834.126933] sd 5:0:0:0: [sdb] Mode Sense: 34 00 00 00
[  834.127679] sd 5:0:0:0: [sdb] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
[  834.167583]  sdb: sdb1 sdb2 < sdb5 >
[  834.170564] sd 5:0:0:0: [sdb] Attached SCSI disk
[ 1042.173146] ISO 9660 Extensions: Microsoft Joliet Level 3
[ 1042.196100] ISOFS: changing to secondary root
[ 1069.155089] firewire_core: phy config: card 0, new root=ffc1, gap_count=5
[ 1099.728129] firewire_core: giving up on config rom for node id ffc0
[ 1354.658101] firewire_ohci: node ID not valid, new bus reset in progress
[ 1354.659096] firewire_ohci: node ID not valid, new bus reset in progress
[ 1354.659250] firewire_core: skipped bus generations, destroying all nodes
[ 1355.156055] firewire_core: rediscovered device fw0
[ 1355.156071] firewire_core: phy config: card 0, new root=ffc1, gap_count=5
[ 1363.157560] firewire_core: phy config: card 0, new root=ffc1, gap_count=5
[ 1364.180453] firewire_core: created device fw1: GUID 00d04b531e08d158, S400, 3 config ROM retries
[ 1364.203849] scsi6 : SBP-2 IEEE-1394
[ 1364.405157] firewire_sbp2: fw1.0: logged in to LUN 0000 (0 retries)
[ 1364.410202] scsi 6:0:0:0: Direct-Access-RBC ST320082 2A               3.01 PQ: 0 ANSI: 4
[ 1364.413039] sd 6:0:0:0: Attached scsi generic sg3 type 14
[ 1364.426862] sd 6:0:0:0: [sdc] 390721968 512-byte logical blocks: (200 GB/186 GiB)
[ 1364.427489] sd 6:0:0:0: [sdc] Write Protect is off
[ 1364.427492] sd 6:0:0:0: [sdc] Mode Sense: 11 00 00 00
[ 1364.428849] sd 6:0:0:0: [sdc] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
[ 1364.439100]  sdc: sdc1
[ 1364.465682] sd 6:0:0:0: [sdc] Attached SCSI disk
[ 2654.984257] iwl4965 0000:03:00.0: iwl4965_tx_agg_start on ra = 64:68:0c:80:62:c1 tid = 6