[   30.223153] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   30.223562] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   30.226479] tg3 0000:09:00.0: irq 45 for MSI/MSI-X
[   30.262822] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[   30.263323] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[   31.313195] bio: create slab <bio-1> at 1
[   33.003035] Adding 2085884k swap on /dev/mapper/cryptswap1.  Priority:-1 extents:1 across:2085884k 
[   34.845196] wlan0: authenticate with 00:1f:90:d5:b7:70
[   34.847471] wlan0: send auth to 00:1f:90:d5:b7:70 (try 1/3)
[   34.849235] wlan0: authenticated
[   34.849488] iwl3945 0000:0c:00.0 wlan0: disabling HT/VHT due to WEP/TKIP use
[   34.849496] iwl3945 0000:0c:00.0 wlan0: disabling HT as WMM/QoS is not supported by the AP
[   34.849502] iwl3945 0000:0c:00.0 wlan0: disabling VHT as WMM/QoS is not supported by the AP
[   34.852064] wlan0: associate with 00:1f:90:d5:b7:70 (try 1/3)
[   34.856787] wlan0: RX AssocResp from 00:1f:90:d5:b7:70 (capab=0x431 status=0 aid=2)
[   34.858178] wlan0: associated
[   34.858226] IPv6: ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[   34.858340] cfg80211: Calling CRDA for country: US
[   34.867270] cfg80211: Regulatory domain changed to country: US
[   34.867282] cfg80211:   (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[   34.867284] cfg80211:   (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm)
[   34.867287] cfg80211:   (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 1700 mBm)
[   34.867289] cfg80211:   (5250000 KHz - 5330000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   34.867292] cfg80211:   (5490000 KHz - 5600000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   34.867294] cfg80211:   (5650000 KHz - 5710000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   34.867297] cfg80211:   (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 3000 mBm)
[   34.958247] wlan0: Limiting TX power to 27 (27 - 0) dBm as advertised by 00:1f:90:d5:b7:70