[   19.619075] ppdev: user-space parallel port driver
[   21.294260] e1000e: eth0 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: RX/TX
[   21.294431] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   32.028006] eth0: no IPv6 routers present
[ 2446.198330] evince[2669]: segfault at 18 ip 05c8eca1 sp b68780f0 error 4 in libpoppler-glib.so.4.0.0[5c79000+2d000]
[ 7662.124020] usb 7-1: new full speed USB device using uhci_hcd and address 2
[ 7662.296130] usb 7-1: configuration #1 chosen from 1 choice
[ 7734.872026] usb 2-5: new high speed USB device using ehci_hcd and address 3
[ 7735.005000] usb 2-5: configuration #1 chosen from 1 choice
[ 7735.040502] Initializing USB Mass Storage driver...
[ 7735.040764] scsi6 : SCSI emulation for USB Mass Storage devices
[ 7735.040861] usb-storage: device found at 3
[ 7735.040865] usb-storage: waiting for device to settle before scanning
[ 7735.040891] usbcore: registered new interface driver usb-storage
[ 7735.040895] USB Mass Storage support registered.
[ 7740.040165] usb-storage: device scan complete
[ 7740.108156] scsi 6:0:0:0: Direct-Access     FUJITSU  MHW2120BH             PQ: 0 ANSI: 2 CCS
[ 7740.108824] sd 6:0:0:0: Attached scsi generic sg2 type 0
[ 7740.110036] sd 6:0:0:0: [sdb] 234441648 512-byte logical blocks: (120 GB/111 GiB)
[ 7740.110589] sd 6:0:0:0: [sdb] Write Protect is off
[ 7740.110593] sd 6:0:0:0: [sdb] Mode Sense: 00 38 00 00
[ 7740.110596] sd 6:0:0:0: [sdb] Assuming drive cache: write through
[ 7740.111757] sd 6:0:0:0: [sdb] Assuming drive cache: write through
[ 7740.111763]  sdb: sdb1
[ 7740.131128] sd 6:0:0:0: [sdb] Assuming drive cache: write through
[ 7740.131133] sd 6:0:0:0: [sdb] Attached SCSI disk
[ 7740.406424] kjournald starting.  Commit interval 5 seconds
[ 7740.406429] EXT3-fs warning: maximal mount count reached, running e2fsck is recommended
[ 7740.406998] EXT3 FS on sdb1, internal journal
[ 7740.407003] EXT3-fs: mounted filesystem with ordered data mode.
[11019.552047] usb 7-1: USB disconnect, address 2
[12578.276023] usb 2-2: new high speed USB device using ehci_hcd and address 4
[12578.414590] usb 2-2: configuration #1 chosen from 1 choice
[12578.414891] scsi7 : SCSI emulation for USB Mass Storage devices
[12578.414993] usb-storage: device found at 4
[12578.414996] usb-storage: waiting for device to settle before scanning
[12583.412152] usb-storage: device scan complete
[12583.412995] scsi 7:0:0:0: Direct-Access     Generic  USB  SD Reader   1.00 PQ: 0 ANSI: 0 CCS
[12583.413427] sd 7:0:0:0: Attached scsi generic sg3 type 0
[12583.416486] sd 7:0:0:0: [sdc] 7843840 512-byte logical blocks: (4.01 GB/3.74 GiB)
[12583.416973] sd 7:0:0:0: [sdc] Write Protect is off
[12583.416976] sd 7:0:0:0: [sdc] Mode Sense: 4b 00 00 08
[12583.416978] sd 7:0:0:0: [sdc] Assuming drive cache: write through
[12583.419347] sd 7:0:0:0: [sdc] Assuming drive cache: write through
[12583.419351]  sdc: sdc1
[12583.421850] sd 7:0:0:0: [sdc] Assuming drive cache: write through
[12583.421854] sd 7:0:0:0: [sdc] Attached SCSI removable disk
[12637.153170] usb 2-2: USB disconnect, address 4