[   17.449695] [fglrx] AGP detected, AgpState   = 0x07000a1b (hardware caps of chipset)
[   17.449704] [fglrx] [agp] enabling AGP with mode=0x07000b1a
[   17.449708] agpgart-via 0000:00:00.0: AGP 3.5 bridge
[   17.449734] agpgart-via 0000:00:00.0: putting AGP V3 device into 8x mode
[   17.449845] fglrx_pci 0000:01:00.0: putting AGP V3 device into 8x mode
[   17.449859] [fglrx] AGP enabled,  AgpCommand = 0x07000312 (selected caps)
[   17.479791] [fglrx] Setup AGP aperture
[   17.584844] [fglrx] Could not enable MSI; System prevented initialization
[   17.585843] [fglrx] Firegl kernel thread PID: 1047
[   17.586124] [fglrx] IRQ 16 Enabled
[   17.669619] ata1.00: exception Emask 0x0 SAct 0x0 SErr 0x0 action 0x6
[   17.669626] ata1.00: BMDMA stat 0x64
[   17.669632] ata1.00: failed command: WRITE DMA
[   17.669640] ata1.00: cmd ca/00:08:40:f7:f2/00:00:00:00:00/e4 tag 0 dma 4096 out
[   17.669642]          res 51/84:00:47:f7:f2/00:00:00:00:00/e4 Emask 0x10 (ATA bus error)
[   17.669646] ata1.00: status: { DRDY ERR }
[   17.669649] ata1.00: error: { ICRC ABRT }
[   17.669682] ata1: soft resetting link
[   17.856971] ata1.00: configured for UDMA/133
[   17.872813] ata1.01: configured for UDMA/66
[   17.873128] ata1: EH complete
[   18.084205] ata1.00: exception Emask 0x0 SAct 0x0 SErr 0x0 action 0x6
[   18.084212] ata1.00: BMDMA stat 0x64
[   18.084218] ata1.00: failed command: WRITE DMA EXT
[   18.084226] ata1.00: cmd 35/00:98:08:50:f2/00:02:06:00:00/e0 tag 0 dma 339968 out
[   18.084228]          res 51/84:00:9f:52:f2/84:00:06:00:00/e6 Emask 0x10 (ATA bus error)
[   18.084232] ata1.00: status: { DRDY ERR }
[   18.084235] ata1.00: error: { ICRC ABRT }
[   18.084264] ata1: soft resetting link
[   18.272482] ata1.00: configured for UDMA/133
[   18.288300] ata1.01: configured for UDMA/66
[   18.288552] ata1: EH complete
[   18.293827] ata1.00: exception Emask 0x0 SAct 0x0 SErr 0x0 action 0x6
[   18.293832] ata1.00: BMDMA stat 0x64
[   18.293838] ata1.00: failed command: WRITE DMA EXT
[   18.293845] ata1.00: cmd 35/00:98:08:50:f2/00:02:06:00:00/e0 tag 0 dma 339968 out
[   18.293847]          res 51/84:00:9f:52:f2/84:00:06:00:00/e6 Emask 0x10 (ATA bus error)
[   18.293851] ata1.00: status: { DRDY ERR }
[   18.293855] ata1.00: error: { ICRC ABRT }
[   18.293877] ata1: soft resetting link
[   18.480473] ata1.00: configured for UDMA/133
[   18.496310] ata1.01: configured for UDMA/66
[   18.496550] ata1: EH complete
[   18.517280] ata1.00: limiting speed to UDMA/100:PIO4
[   18.517287] ata1.00: exception Emask 0x0 SAct 0x0 SErr 0x0 action 0x6
[   18.517292] ata1.00: BMDMA stat 0x64
[   18.517298] ata1.00: failed command: WRITE DMA
[   18.517306] ata1.00: cmd ca/00:40:40:b0:84/00:00:00:00:00/e8 tag 0 dma 32768 out
[   18.517307]          res 51/84:00:7f:b0:84/84:00:06:00:00/e8 Emask 0x10 (ATA bus error)
[   18.517312] ata1.00: status: { DRDY ERR }
[   18.517315] ata1.00: error: { ICRC ABRT }
[   18.517344] ata1: soft resetting link
[   18.704498] ata1.00: configured for UDMA/100
[   18.720297] ata1.01: configured for UDMA/66
[   18.720539] ata1: EH complete
[   19.387396] [fglrx] Gart cacheable size:875 M.
[   19.387406] [fglrx] Reserved FB block: Shared offset:0, size:1000000 
[   19.387410] [fglrx] Reserved FB block: Unshared offset:fe08000, size:1f8000 
[   19.387414] [fglrx] Reserved FB block: Unshared offset:1fffc000, size:4000 
[   25.852523] eth0: no IPv6 routers present
[   26.140521] eth1: no IPv6 routers present
[   47.276018] usb 3-2: new full speed USB device using uhci_hcd and address 3
[   47.796018] usb 3-2: device not accepting address 3, error -71
[   47.852053] hub 3-0:1.0: unable to enumerate USB device on port 2
[   49.000025] usb 3-2: new full speed USB device using uhci_hcd and address 5
[   49.164163] usb 3-2: configuration #1 chosen from 1 choice
[   50.322994] Initializing USB Mass Storage driver...
[   50.511867] scsi4 : SCSI emulation for USB Mass Storage devices
[   50.512039] usbcore: registered new interface driver usb-storage
[   50.512044] USB Mass Storage support registered.
[   50.515035] usb-storage: device found at 5
[   50.515039] usb-storage: waiting for device to settle before scanning
[   50.744054] usb 3-2: USB disconnect, address 5
[   57.680024] usb 3-2: new full speed USB device using uhci_hcd and address 6
[   57.839342] usb 3-2: configuration #1 chosen from 1 choice
[   57.887852] cdc_acm 3-2:1.0: ttyACM0: USB ACM device
[   57.890346] usbcore: registered new interface driver cdc_acm
[   57.890352] cdc_acm: v0.26:USB Abstract Control Model driver for USB modems and ISDN adapters
[   71.576080] usb 3-2: USB disconnect, address 6
[   73.056061] usb 3-2: new full speed USB device using uhci_hcd and address 7
[   73.219535] usb 3-2: configuration #1 chosen from 1 choice
[   73.226404] scsi5 : SCSI emulation for USB Mass Storage devices
[   73.226623] usb-storage: device found at 7
[   73.226626] usb-storage: waiting for device to settle before scanning