Error: command ['sh', '-c', 'dmesg | comm -13 /var/log/dmesg -'] failed with exit code 1: [   43.096377] e1000e 0000:00:19.0: irq 31 for MSI/MSI-X
[   43.152240] e1000e 0000:00:19.0: irq 31 for MSI/MSI-X
[   43.152541] ADDRCONF(NETDEV_UP): eth0: link is not ready
[   43.153531] iwlagn 0000:03:00.0: firmware: requesting iwlwifi-4965-2.ucode
[   43.235444] iwlagn 0000:03:00.0: loaded firmware version 228.61.2.24
[   43.454424] Registered led device: iwl-phy0::radio
[   43.454453] Registered led device: iwl-phy0::assoc
[   43.454474] Registered led device: iwl-phy0::RX
[   43.454485] Registered led device: iwl-phy0::TX
[   43.502911] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   50.229053] CE: hpet increasing min_delta_ns to 15000 nsec
[   51.168052] CE: hpet increasing min_delta_ns to 22500 nsec
[   51.668977] e1000e: eth0 NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX
[   51.668980] 0000:00:19.0: eth0: 10/100 speed: disabling TSO
[   51.669207] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   61.868050] eth0: no IPv6 routers present
comm: file 2 is not in sorted order
[  158.263871] kjournald starting.  Commit interval 5 seconds
[  158.264134] EXT3 FS on sda4, internal journal
[  158.264141] EXT3-fs: mounted filesystem with writeback data mode.
[  205.835796] process `skype.real' is using obsolete setsockopt SO_BSDCOMPAT
[ 3786.060017] hda-intel: azx_get_response timeout, switching to polling mode: last cmd=0x012f0c00
[27507.435419] <6>gwibber[8898]: segfault at aaaaaaae ip b721bb06 sp bfd15d30 error 4 in libpango-1.0.so.0.2400.4[b71fc000+45000]