Comment 28 for bug 1853638

Revision history for this message
Nivedita Singhvi (niveditasinghvi) wrote :

ethtool-enp94s0f0
----------------------
Settings for enp94s0f0:
 Supported ports: [ FIBRE ]
 Supported link modes: 10000baseT/Full
 Supported pause frame use: Symmetric Receive-only
 Supports auto-negotiation: Yes
 Supported FEC modes: Not reported
 Advertised link modes: Not reported
 Advertised pause frame use: No
 Advertised auto-negotiation: No
 Advertised FEC modes: Not reported
 Speed: 10000Mb/s
 Duplex: Full
 Port: FIBRE
 PHYAD: 1
 Transceiver: internal
 Auto-negotiation: off
 Supports Wake-on: g
 Wake-on: d
 Current message level: 0x00000000 (0)

 Link detected: yes

ethtool-i-enp94s0f0
--------------------------
driver: bnxt_en
version: 1.10.0
firmware-version: 214.0.253.1/pkg 21.40.25.31
expansion-rom-version:
bus-info: 0000:5e:00.0
supports-statistics: yes
supports-test: yes
supports-eeprom-access: yes
supports-register-dump: no
supports-priv-flags: no

ethtool-c-enp94s0f0
---------------------
Coalesce parameters for enp94s0f0:
Adaptive RX: off TX: off
stats-block-usecs: 1000000
sample-interval: 0
pkt-rate-low: 0
pkt-rate-high: 0

rx-usecs: 10
rx-frames: 15
rx-usecs-irq: 1
rx-frames-irq: 1

tx-usecs: 28
tx-frames: 30
tx-usecs-irq: 2
tx-frames-irq: 2

rx-usecs-low: 0
rx-frame-low: 0
tx-usecs-low: 0
tx-frame-low: 0

rx-usecs-high: 0
rx-frame-high: 0
tx-usecs-high: 0
tx-frame-high: 0

ethtool-g-enp94s0f0
------------------------
Ring parameters for enp94s0f0:
Pre-set maximums:
RX: 2047
RX Mini: 0
RX Jumbo: 8191
TX: 2047
Current hardware settings:
RX: 511
RX Mini: 0
RX Jumbo: 2044
TX: 511

ethtool-k-enp94s0f0
---------------------
Features for enp94s0f0:
rx-checksumming: on
tx-checksumming: on
 tx-checksum-ipv4: on
 tx-checksum-ip-generic: off [fixed]
 tx-checksum-ipv6: on
 tx-checksum-fcoe-crc: off [fixed]
 tx-checksum-sctp: off [fixed]
scatter-gather: on
 tx-scatter-gather: on
 tx-scatter-gather-fraglist: off [fixed]
tcp-segmentation-offload: on
 tx-tcp-segmentation: on
 tx-tcp-ecn-segmentation: off [fixed]
 tx-tcp-mangleid-segmentation: off
 tx-tcp6-segmentation: on
udp-fragmentation-offload: off
generic-segmentation-offload: on
generic-receive-offload: on
large-receive-offload: off
rx-vlan-offload: on
tx-vlan-offload: on
ntuple-filters: on
receive-hashing: on
highdma: on [fixed]
rx-vlan-filter: off [fixed]
vlan-challenged: off [fixed]
tx-lockless: off [fixed]
netns-local: off [fixed]
tx-gso-robust: off [fixed]
tx-fcoe-segmentation: off [fixed]
tx-gre-segmentation: on
tx-gre-csum-segmentation: on
tx-ipxip4-segmentation: on
tx-ipxip6-segmentation: off [fixed]
tx-udp_tnl-segmentation: on
tx-udp_tnl-csum-segmentation: on
tx-gso-partial: on
tx-sctp-segmentation: off [fixed]
tx-esp-segmentation: off [fixed]
tx-udp-segmentation: off [fixed]
fcoe-mtu: off [fixed]
tx-nocache-copy: off
loopback: off [fixed]
rx-fcs: off [fixed]
rx-all: off [fixed]
tx-vlan-stag-hw-insert: on
rx-vlan-stag-hw-parse: on
rx-vlan-stag-filter: off [fixed]
l2-fwd-offload: off [fixed]
hw-tc-offload: on
esp-hw-offload: off [fixed]
esp-tx-csum-hw-offload: off [fixed]
rx-udp_tunnel-port-offload: on
tls-hw-tx-offload: off [fixed]
tls-hw-rx-offload: off [fixed]
rx-gro-hw: on
tls-hw-record: off [fixed]