Comment 2 for bug 156490

Revision history for this message
Stephen Gornick (sgornick) wrote :

I get about the same thing.

After clicking Shut Down, a few seconds pass, then this is displayed on the console:

NetworkManager: <info> Caught termination signal

NetworkManager: <debug> [1193029284.958940] nm_print_open_socks(): Open Sockets List

NetworkManager: <debug> [1193029284.959004] nm_print_open_socks(): Open Sockets List Done

NetworkManager: <info> Deactivating device eth0

NetworkManager: <info> Deactivating device eth1

Then nothing. I've waited as long as 10 minutes, with no additional message. The only way to proceed from there is to power off (hold power button for 5 seconds).

This is on my HP Pavilion ZX5000 ( zx5078cl ) which has a Broadcom 43xx.

02:02.0 Network controller: Broadcom Corporation BCM4306 802.11b/g Wireless LAN Controller (rev 03)
        Subsystem: Hewlett-Packard Company NX9500 Built-in Wireless
        Flags: bus master, fast devsel, latency 64, IRQ 19
        Memory at e8204000 (32-bit, non-prefetchable) [size=8K]

02:03.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)
        Subsystem: Hewlett-Packard Company Unknown device 006b
        Flags: bus master, medium devsel, latency 128, IRQ 18
        I/O ports at a000 [size=256]
        Memory at e8208800 (32-bit, non-prefetchable) [size=256]
        Capabilities: <access denied>

Clean install Ubuntu Gutsy i386 7.10 release.

I've seen other bug reports listing shutdown issues (Bug #138691 [gutsy], 137663 [feisty], 121658 [feisty] ) but I cannot tell if any are related to this issue.