[   29.264877] vboxdrv: Found 1 processor cores.
[   29.267558] vboxdrv: TSC mode is 'synchronous', kernel timer mode is 'normal'.
[   29.267563] vboxdrv: Successfully loaded version 4.0.2 (interface 0x00160000).
[   30.548067] wlan0: authenticate with 00:02:8a:fb:74:06 (try 1)
[   30.549894] wlan0: authenticated
[   30.549920] wlan0: associate with 00:02:8a:fb:74:06 (try 1)
[   30.551932] wlan0: RX AssocResp from 00:02:8a:fb:74:06 (capab=0x401 status=0 aid=4)
[   30.551938] wlan0: associated
[   30.553183] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[   32.251659] EXT4-fs (sda6): re-mounted. Opts: errors=remount-ro,commit=0
[   40.656047] wlan0: no IPv6 routers present
[ 2249.930563] cfg80211: Found new beacon on frequency: 2472 MHz (Ch 13) on phy0
[10164.140086] usb 1-2: new high speed USB device using ehci_hcd and address 2
[10164.892695] Initializing USB Mass Storage driver...
[10164.895997] scsi4 : usb-storage 1-2:1.0
[10164.896991] usbcore: registered new interface driver usb-storage
[10164.896998] USB Mass Storage support registered.
[10165.905255] scsi 4:0:0:0: Direct-Access     FUJIFILM USB-DRIVEUNIT    1.00 PQ: 0 ANSI: 0 CCS
[10165.910807] sd 4:0:0:0: Attached scsi generic sg2 type 0
[10165.915588] sd 4:0:0:0: [sdb] 1023120 512-byte logical blocks: (523 MB/499 MiB)
[10165.916831] sd 4:0:0:0: [sdb] Write Protect is off
[10165.916841] sd 4:0:0:0: [sdb] Mode Sense: 07 00 00 00
[10165.916848] sd 4:0:0:0: [sdb] Assuming drive cache: write through
[10165.922079] sd 4:0:0:0: [sdb] Assuming drive cache: write through
[10165.922107]  sdb: sdb1
[10165.929970] sd 4:0:0:0: [sdb] Assuming drive cache: write through
[10165.929984] sd 4:0:0:0: [sdb] Attached SCSI removable disk
[10341.272519] usb 1-2: USB disconnect, address 2
[10341.272774] sd 4:0:0:0: [sdb] Unhandled error code
[10341.272781] sd 4:0:0:0: [sdb] Result: hostbyte=DID_ERROR driverbyte=DRIVER_OK
[10341.272792] sd 4:0:0:0: [sdb] CDB: Read(10): 28 00 00 07 e3 00 00 00 f0 00
[10341.272816] end_request: I/O error, dev sdb, sector 516864
[10341.273241] sd 4:0:0:0: [sdb] Unhandled error code
[10341.273248] sd 4:0:0:0: [sdb] Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK
[10341.273257] sd 4:0:0:0: [sdb] CDB: Read(10): 28 00 00 07 e3 f0 00 00 10 00
[10341.273279] end_request: I/O error, dev sdb, sector 517104
[10341.273321] sd 4:0:0:0: [sdb] Unhandled error code
[10341.273327] sd 4:0:0:0: [sdb] Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK
[10341.273335] sd 4:0:0:0: [sdb] CDB: Read(10): 28 00 00 07 e4 00 00 00 f0 00
[10341.273354] end_request: I/O error, dev sdb, sector 517120
[10341.604059] usb 1-2: new high speed USB device using ehci_hcd and address 3
[10341.756275] scsi5 : usb-storage 1-2:1.0
[10342.767077] scsi 5:0:0:0: Direct-Access     FUJIFILM USB-DRIVEUNIT    1.00 PQ: 0 ANSI: 0 CCS
[10342.772717] sd 5:0:0:0: Attached scsi generic sg2 type 0
[10342.780285] sd 5:0:0:0: [sdc] 1023120 512-byte logical blocks: (523 MB/499 MiB)
[10342.783288] sd 5:0:0:0: [sdc] Write Protect is off
[10342.783300] sd 5:0:0:0: [sdc] Mode Sense: 07 00 00 00
[10342.783307] sd 5:0:0:0: [sdc] Assuming drive cache: write through
[10342.786273] sd 5:0:0:0: [sdc] Assuming drive cache: write through
[10342.786297]  sdc: sdc1
[10342.802703] sd 5:0:0:0: [sdc] Assuming drive cache: write through
[10342.802718] sd 5:0:0:0: [sdc] Attached SCSI removable disk
[11518.865472] show_signal_msg: 15 callbacks suppressed
[11518.865479] nautilus[1367]: segfault at 9 ip 002b126a sp bff86a80 error 4 in libgobject-2.0.so.0.2600.0[2a3000+40000]
[11537.621621] usb 1-2: USB disconnect, address 3
[12394.542128] EXT4-fs (sda6): re-mounted. Opts: errors=remount-ro,commit=600
[12472.744121] EXT4-fs (sda6): re-mounted. Opts: errors=remount-ro,commit=0
[12919.447659] EXT4-fs (sda5): warning: maximal mount count reached, running e2fsck is recommended
[12919.448035] EXT4-fs (sda5): mounted filesystem with ordered data mode. Opts: (null)
[14458.364339] ghex2[3260]: segfault at 50203a29 ip 00415964 sp bfcf3280 error 4 in libpango-1.0.so.0.2800.1[402000+3f000]
[19614.806497] hda-intel: azx_get_response timeout, switching to polling mode: last cmd=0x10a90000
[19615.808017] hda_intel: azx_get_response timeout, switching to single_cmd mode: last cmd=0x10a90000