[ 15.820093] Skipping EDID probe due to cached edid [ 15.953249] vboxdrv: Trying to deactivate the NMI watchdog permanently... [ 15.953252] vboxdrv: Successfully done. [ 15.953254] vboxdrv: Found 2 processor cores. [ 15.953768] VBoxDrv: dbg - g_abExecMemory=ffffffffa042ed60 [ 15.953783] vboxdrv: fAsync=0 offMin=0x1b0 offMax=0x69c [ 15.954396] vboxdrv: TSC mode is 'synchronous', kernel timer mode is 'normal'. [ 15.954398] vboxdrv: Successfully loaded version 3.2.8 (interface 0x00140001). [ 16.500657] Skipping EDID probe due to cached edid [ 16.640062] Skipping EDID probe due to cached edid [ 16.831321] Skipping EDID probe due to cached edid [ 16.881348] Skipping EDID probe due to cached edid [ 17.117327] tg3 0000:04:00.0: eth0: Link is up at 100 Mbps, full duplex [ 17.117330] tg3 0000:04:00.0: eth0: Flow control is on for TX and on for RX [ 17.117558] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready [ 17.528844] EXT4-fs (sda1): re-mounted. Opts: errors=remount-ro,commit=0 [ 24.834601] Intel AES-NI instructions are not detected. [ 24.882354] padlock: VIA PadLock not detected. [ 27.670072] eth0: no IPv6 routers present [ 28.030133] Skipping EDID probe due to cached edid [ 28.081368] Skipping EDID probe due to cached edid [ 28.131404] Skipping EDID probe due to cached edid [ 29.611348] Skipping EDID probe due to cached edid [ 39.230083] Skipping EDID probe due to cached edid [ 144.222275] show_signal_msg: 12 callbacks suppressed [ 144.222280] empathy[1921]: segfault at ffffffff ip 00007f60c6206f74 sp 00007fff1eced040 error 4 in libglib-2.0.so.0.2600.0[7f60c61a9000+e0000] [ 615.460122] CE: hpet increased min_delta_ns to 7500 nsec [ 1625.460120] CE: hpet increased min_delta_ns to 11250 nsec [ 4027.790122] usb 6-2: USB disconnect, address 2 [ 4030.561364] usb 6-2: new low speed USB device using uhci_hcd and address 3 [ 4030.760297] input: Logitech USB Receiver as /devices/pci0000:00/0000:00:1d.0/usb6/6-2/6-2:1.0/input/input12 [ 4030.760558] generic-usb 0003:046D:C50E.0002: input,hidraw0: USB HID v1.11 Mouse [Logitech USB Receiver] on usb-0000:00:1d.0-2/input0