[  254.984285] rt2800pci 0000:01:00.0: PCI INT A disabled
[  258.925076] pci 0000:01:00.0: reg 10: [mem 0x00000000-0x0000ffff]
[  258.925223] pci 0000:01:00.0: PME# supported from D0 D3hot
[  258.925240] pci 0000:01:00.0: PME# disabled
[  258.925287] pci 0000:01:00.0: BAR 0: assigned [mem 0xf8000000-0xf800ffff]
[  258.925310] pci 0000:01:00.0: BAR 0: set to [mem 0xf8000000-0xf800ffff] (PCI address [0xf8000000-0xf800ffff]
[  258.925622] rt2800pci 0000:01:00.0: enabling device (0000 -> 0002)
[  258.925657] rt2800pci 0000:01:00.0: PCI INT A -> GSI 19 (level, low) -> IRQ 19
[  258.925687] rt2800pci 0000:01:00.0: setting latency timer to 64
[  259.037836] phy1: Selected rate control algorithm 'minstrel'
[  259.043980] Registered led device: rt2800pci-phy1::radio
[  259.047253] Registered led device: rt2800pci-phy1::assoc
[  259.047792] Registered led device: rt2800pci-phy1::quality
[  259.585707] phy1 -> rt2800pci_mcu_status: Error - MCU request failed, no response from hardware
[  259.645031] ADDRCONF(NETDEV_UP): wlan0: link is not ready