[   24.096045] pcmcia_socket pcmcia_socket0: pccard: CardBus card inserted into slot 0
[   24.096095] pci 0000:03:00.0: reg 14: [mem 0x00000000-0x000000ff]
[   24.096115] pci 0000:03:00.0: reg 20: [io  0xfce0-0xfcff]
[   24.096156] pci 0000:03:00.0: supports D1 D2
[   24.096159] pci 0000:03:00.0: PME# supported from D0 D1 D2 D3hot D3cold
[   24.096166] pci 0000:03:00.0: PME# disabled
[   24.096206] pci 0000:03:00.2: reg 10: [mem 0x00000000-0x000000ff]
[   24.096215] pci 0000:03:00.2: reg 14: [mem 0x00000000-0x000000ff]
[   24.096266] pci 0000:03:00.2: supports D1 D2
[   24.096269] pci 0000:03:00.2: PME# supported from D0 D1 D2 D3hot D3cold
[   24.096275] pci 0000:03:00.2: PME# disabled
[   24.096299] pci 0000:03:00.0: BAR 1: assigned [mem 0xc4000000-0xc40000ff]
[   24.096307] pci 0000:03:00.0: BAR 1: set to [mem 0xc4000000-0xc40000ff] (PCI address [0xc4000000-0xc40000ff]
[   24.096312] pci 0000:03:00.2: BAR 0: assigned [mem 0xc4000100-0xc40001ff]
[   24.096319] pci 0000:03:00.2: BAR 0: set to [mem 0xc4000100-0xc40001ff] (PCI address [0xc4000100-0xc40001ff]
[   24.096324] pci 0000:03:00.2: BAR 1: assigned [mem 0xc4000200-0xc40002ff]
[   24.096331] pci 0000:03:00.2: BAR 1: set to [mem 0xc4000200-0xc40002ff] (PCI address [0xc4000200-0xc40002ff]
[   24.096336] pci 0000:03:00.0: BAR 4: assigned [io  0x4000-0x401f]
[   24.096342] pci 0000:03:00.0: BAR 4: set to [io  0x4000-0x401f] (PCI address [0x4000-0x401f]
[   24.096481] uhci_hcd 0000:03:00.0: enabling device (0000 -> 0003)
[   24.096494] uhci_hcd 0000:03:00.0: PCI INT A -> Link[LNKA] -> GSI 11 (level, low) -> IRQ 11
[   24.096510] uhci_hcd 0000:03:00.0: UHCI Host Controller
[   24.096619] uhci_hcd 0000:03:00.0: new USB bus registered, assigned bus number 5
[   24.096658] uhci_hcd 0000:03:00.0: irq 11, io base 0x00004000
[   24.096879] hub 5-0:1.0: USB hub found
[   24.096886] hub 5-0:1.0: 2 ports detected
[   24.097037] ehci_hcd 0000:03:00.2: enabling device (0000 -> 0002)
[   24.097046] ehci_hcd 0000:03:00.2: PCI INT A -> Link[LNKA] -> GSI 11 (level, low) -> IRQ 11
[   24.097073] ehci_hcd 0000:03:00.2: EHCI Host Controller
[   24.097126] ehci_hcd 0000:03:00.2: new USB bus registered, assigned bus number 6
[   24.097175] ehci_hcd 0000:03:00.2: irq 11, io mem 0xc4000100
[   24.108450] ehci_hcd 0000:03:00.2: USB 2.0 started, EHCI 1.00
[   24.108711] hub 6-0:1.0: USB hub found
[   24.108719] hub 6-0:1.0: 2 ports detected
[   24.109231] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x100-0x3af: excluding 0x170-0x177 0x1f0-0x1f7 0x370-0x377
[   24.110299] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x3e0-0x4ff: excluding 0x3f0-0x3ff 0x4d0-0x4d7
[   24.110765] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x820-0x8ff: clean.
[   24.112909] pcmcia_socket pcmcia_socket0: cs: IO port probe 0xc00-0xcf7: clean.
[   24.113348] pcmcia_socket pcmcia_socket0: cs: memory probe 0x0c0000-0x0fffff: excluding 0xc0000-0xd3fff 0xdc000-0xfffff
[   24.113426] pcmcia_socket pcmcia_socket0: cs: memory probe 0xa0000000-0xa0ffffff: clean.
[   24.113502] pcmcia_socket pcmcia_socket0: cs: memory probe 0x60000000-0x60ffffff: clean.
[   24.113584] pcmcia_socket pcmcia_socket0: cs: IO port probe 0xa00-0xaff: clean.
[   24.183708] CPUFREQ: Per core ondemand sysfs interface is deprecated - ignore_nice_load
[   24.544092] usb 6-1: new high speed USB device using ehci_hcd and address 2
[   24.696090] intel8x0_measure_ac97_clock: measured 55214 usecs (2660 samples)
[   24.696103] intel8x0: clocking to 48000
[   24.702241] ata1.00: configured for UDMA/100
[   24.702259] ata1: EH complete
[   24.705096] sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
[   24.767352] Initializing USB Mass Storage driver...
[   24.772425] scsi2 : usb-storage 6-1:1.0
[   24.772731] usbcore: registered new interface driver usb-storage
[   24.772735] USB Mass Storage support registered.
[   25.244213] agpgart-intel 0000:00:00.0: AGP 2.0 bridge
[   25.244233] agpgart-intel 0000:00:00.0: putting AGP V2 device into 4x mode
[   25.244276] pci 0000:01:00.0: putting AGP V2 device into 4x mode
[   25.464757] [drm] Setting GART location based on new memory map
[   25.465808] [drm] Loading R100 Microcode
[   25.473874] [drm] writeback test succeeded in 1 usecs
[   25.834078] psmouse serio2: ID: 10 00 64
[   25.904961] scsi 2:0:0:0: Direct-Access     Multiple Card  Reader     1.00 PQ: 0 ANSI: 0
[   25.910720] sd 2:0:0:0: Attached scsi generic sg2 type 0
[   26.629539] sd 2:0:0:0: [sdb] 3987456 512-byte logical blocks: (2.04 GB/1.90 GiB)
[   26.630381] sd 2:0:0:0: [sdb] Write Protect is off
[   26.630393] sd 2:0:0:0: [sdb] Mode Sense: 03 00 00 00
[   26.630401] sd 2:0:0:0: [sdb] Assuming drive cache: write through
[   26.636774] sd 2:0:0:0: [sdb] Assuming drive cache: write through
[   26.636798]  sdb: sdb1
[   26.647643] sd 2:0:0:0: [sdb] Assuming drive cache: write through
[   26.647660] sd 2:0:0:0: [sdb] Attached SCSI removable disk
[   26.764130] EXT4-fs (sda1): re-mounted. Opts: errors=remount-ro,commit=600
[   29.130905] IBM TrackPoint firmware: 0x0e, buttons: 3/3
[   29.338025] input: TPPS/2 IBM TrackPoint as /devices/platform/i8042/serio1/serio2/input/input7
[   31.132460] ata1.00: configured for UDMA/100
[   31.132472] ata1: EH complete
[   32.606951] EXT4-fs (sda1): re-mounted. Opts: errors=remount-ro,commit=600
[   41.921774] padlock: VIA PadLock not detected.
[   58.512748] lo: Disabled Privacy Extensions
[   64.548721] ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready
[   66.119730] lib80211_crypt: registered algorithm 'CCMP'
[   66.370925] lib80211_crypt: registered algorithm 'TKIP'
[   74.688050] eth1: no IPv6 routers present
[  302.968630] ADDRCONF(NETDEV_UP): eth1: link is not ready
[  303.884717] ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready
[  314.288051] eth1: no IPv6 routers present
[  431.674621] ADDRCONF(NETDEV_UP): eth1: link is not ready
[  432.548679] ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready
[  442.880047] eth1: no IPv6 routers present
[  459.552861] ADDRCONF(NETDEV_UP): eth1: link is not ready
[  460.468700] ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready
[  470.488048] eth1: no IPv6 routers present
[ 1820.644585] lo: Disabled Privacy Extensions
[ 2429.728642] ata1.00: configured for UDMA/100
[ 2429.728661] ata1: EH complete
[ 2429.819449] sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
[ 2432.714974] EXT4-fs (sda1): re-mounted. Opts: errors=remount-ro,commit=0