[   30.087923] vga16fb: initializing
[   30.087929] vga16fb: mapped to 0xc00a0000
[   30.088226] fb0: VGA16 VGA frame buffer device
[   30.291635] phy0: Selected rate control algorithm 'minstrel'
[   30.293189] Registered led device: b43-phy0::tx
[   30.293329] Registered led device: b43-phy0::rx
[   30.293398] Registered led device: b43-phy0::radio
[   30.294680] Broadcom 43xx driver loaded [ Features: PL, Firmware-ID: FW13 ]
[   30.360719] b43 ssb0:0: firmware: requesting b43/ucode5.fw
[   30.362343] Bluetooth: L2CAP ver 2.14
[   30.362346] Bluetooth: L2CAP socket layer initialized
[   30.365759] b43 ssb0:0: firmware: requesting b43/pcm5.fw
[   30.370998] b43 ssb0:0: firmware: requesting b43/b0g0initvals5.fw
[   30.372482] Console: switching to colour frame buffer device 80x30
[   30.381861] b43 ssb0:0: firmware: requesting b43/b0g0bsinitvals5.fw
[   30.492146] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[   30.492151] Bluetooth: BNEP filters: protocol multicast
[   30.509258] b43-phy0: Loading firmware version 410.2160 (2007-05-26 15:32:10)
[   30.569766] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   30.633086] Bluetooth: SCO (Voice Link) ver 0.6
[   30.633092] Bluetooth: SCO socket layer initialized
[   30.947006] Intel ICH 0000:00:1f.5: PCI INT B -> Link[LNKB] -> GSI 10 (level, low) -> IRQ 10
[   30.947060] Intel ICH 0000:00:1f.5: setting latency timer to 64
[   30.965605] lp: driver loaded but no devices found
[   30.988650] Bluetooth: RFCOMM TTY layer initialized
[   30.988663] Bluetooth: RFCOMM socket layer initialized
[   30.988666] Bluetooth: RFCOMM ver 1.11
[   31.009407] ppdev: user-space parallel port driver
[   31.726422] cfg80211: Found new beacon on frequency: 2472 MHz (Ch 13) on phy0
[   31.772027] intel8x0_measure_ac97_clock: measured 55399 usecs (2669 samples)
[   31.772032] intel8x0: clocking to 48000
[   32.856399] ata1.00: configured for UDMA/100
[   32.856408] ata1: EH complete
[   33.240131] wlan0: direct probe to AP 00:1d:0f:e7:2d:a4 (try 1)
[   33.242573] wlan0: direct probe responded
[   33.242577] wlan0: authenticate with AP 00:1d:0f:e7:2d:a4 (try 1)
[   33.244336] wlan0: authenticated
[   33.244353] wlan0: associate with AP 00:1d:0f:e7:2d:a4 (try 1)
[   33.247912] wlan0: RX AssocResp from 00:1d:0f:e7:2d:a4 (capab=0x431 status=0 aid=2)
[   33.247915] wlan0: associated
[   33.248888] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[   33.248953] cfg80211: Calling CRDA for country: PL
[   33.260479] cfg80211: Received country IE:
[   33.260483] cfg80211: Regulatory domain: PL
[   33.260485] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[   33.260489] 	(2402000 KHz - 2494000 KHz @ 40000 KHz), (10000 mBi, 10000 mBm)
[   33.260492] cfg80211: CRDA thinks this should applied:
[   33.260494] cfg80211: Regulatory domain: PL
[   33.260496] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[   33.260499] 	(2402000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm)
[   33.260503] 	(5170000 KHz - 5250000 KHz @ 40000 KHz), (N/A, 2000 mBm)
[   33.260506] 	(5250000 KHz - 5330000 KHz @ 40000 KHz), (N/A, 2000 mBm)
[   33.260509] 	(5490000 KHz - 5710000 KHz @ 40000 KHz), (N/A, 2700 mBm)
[   33.260511] cfg80211: We intersect both of these and get:
[   33.260514] cfg80211: Regulatory domain: 98
[   33.260516] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[   33.260519] 	(2402000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm)
[   33.260526] cfg80211: Disabling channel 2484 MHz on phy0 due to Country IE
[   33.260531] cfg80211: Current regulatory domain updated by AP to: PL
[   33.260533] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[   33.260537] 	(2402000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm)
[   34.309991] padlock: VIA PadLock not detected.
[   43.672020] wlan0: no IPv6 routers present
[   45.217019] tg3: eth0: Link is up at 10 Mbps, full duplex.
[   45.217023] tg3: eth0: Flow control is on for TX and on for RX.
[   45.217292] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   55.932028] eth0: no IPv6 routers present
[  821.087171] udev[12456]: starting version 162
[ 6114.338332] mtrr: base(0xe8000000) is not aligned on a size(0x7d0000) boundary
[ 6122.692430] ata1.00: configured for UDMA/100
[ 6122.692443] ata1: EH complete
[ 6167.758484] lo: Disabled Privacy Extensions
[ 6421.994765] lo: Disabled Privacy Extensions