[   17.755816] Registered led device: iwl-phy0::radio
[   17.756172] Registered led device: iwl-phy0::assoc
[   17.756432] Registered led device: iwl-phy0::RX
[   17.756684] Registered led device: iwl-phy0::TX
[   17.872163] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   18.742294] vboxdrv: Trying to deactivate the NMI watchdog permanently...
[   18.742298] vboxdrv: Warning: 2.6.31+ kernel detected. Most likely the hardware performance
[   18.742299] vboxdrv: counter framework which can generate NMIs is active. You have to prevent
[   18.742300] vboxdrv: the usage of hardware performance counters by
[   18.742301] vboxdrv:   echo 2 > /proc/sys/kernel/perf_counter_paranoid
[   18.742305] vboxdrv: Found 2 processor cores.
[   18.742408] VBoxDrv: dbg - g_abExecMemory=ffffffffa0333a20
[   18.742426] vboxdrv: fAsync=0 offMin=0x157 offMax=0xd43
[   18.743043] vboxdrv: TSC mode is 'synchronous', kernel timer mode is 'normal'.
[   18.743046] vboxdrv: Successfully loaded version 3.1.6_OSE (interface 0x00100001).
[   18.834310] Bluetooth: L2CAP ver 2.14
[   18.834313] Bluetooth: L2CAP socket layer initialized
[   18.852075] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[   18.852078] Bluetooth: BNEP filters: protocol multicast
[   18.869574] Bridge firewalling registered
[   18.890054] ppdev: user-space parallel port driver
[   18.893909] Bluetooth: SCO (Voice Link) ver 0.6
[   18.893911] Bluetooth: SCO socket layer initialized
[   19.001262] Bluetooth: RFCOMM TTY layer initialized
[   19.001266] Bluetooth: RFCOMM socket layer initialized
[   19.001268] Bluetooth: RFCOMM ver 1.11
[   19.113091] CPU0 attaching NULL sched-domain.
[   19.113095] CPU1 attaching NULL sched-domain.
[   19.170134] CPU0 attaching sched-domain:
[   19.170137]  domain 0: span 0-1 level MC
[   19.170140]   groups: 0 1
[   19.170145] CPU1 attaching sched-domain:
[   19.170147]  domain 0: span 0-1 level MC
[   19.170150]   groups: 1 0
[   20.550900] cfg80211: Found new beacon on frequency: 5745 MHz (Ch 149) on phy0
[   20.650836] e1000e: eth0 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: RX/TX
[   20.651354] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   21.905096] CPU0 attaching NULL sched-domain.
[   21.905102] CPU1 attaching NULL sched-domain.
[   21.960126] CPU0 attaching sched-domain:
[   21.960131]  domain 0: span 0-1 level MC
[   21.960134]   groups: 0 1
[   21.960140] CPU1 attaching sched-domain:
[   21.960142]  domain 0: span 0-1 level MC
[   21.960144]   groups: 1 0
[   31.320006] eth0: no IPv6 routers present
[   35.075254] wlan0: deauthenticating from 00:25:9c:48:86:f6 by local choice (reason=3)
[   35.075389] wlan0: direct probe to AP 00:25:9c:48:86:f6 (try 1)
[   35.270046] wlan0: direct probe to AP 00:25:9c:48:86:f6 (try 2)
[   35.270912] wlan0: direct probe responded
[   35.270914] wlan0: authenticate with AP 00:25:9c:48:86:f6 (try 1)
[   35.271436] wlan0: authenticated
[   35.271450] wlan0: associate with AP 00:25:9c:48:86:f6 (try 1)
[   35.272287] wlan0: RX AssocResp from 00:25:9c:48:86:f6 (capab=0x11 status=0 aid=1)
[   35.272290] wlan0: associated
[   35.273899] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[   35.331361] Intel AES-NI instructions are not detected.
[   35.366371] padlock: VIA PadLock not detected.
[   46.070298] wlan0: no IPv6 routers present
[   72.739400] lo: Disabled Privacy Extensions