[   13.933435] sky2 0000:02:00.0: eth0: Link is up at 100 Mbps, full duplex, flow control rx
[   13.934104] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   15.132807] ata3.00: configured for UDMA/133
[   15.132811] ata3: EH complete
[   16.763514] EXT4-fs (sda3): re-mounted. Opts: errors=remount-ro,commit=0
[   16.766619] EXT4-fs (sda5): re-mounted. Opts: commit=0
[   24.200021] eth0: no IPv6 routers present
[  524.211616] ata3.00: configured for UDMA/133
[  524.211634] ata3: EH complete
[  524.220372] sd 2:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
[  526.891282] EXT4-fs (sda3): re-mounted. Opts: errors=remount-ro,commit=600
[  527.618328] EXT4-fs (sda5): re-mounted. Opts: commit=600
[  579.305152] process `skype' is using obsolete setsockopt SO_BSDCOMPAT
[ 3185.292614] usb 2-1: USB disconnect, address 2
[ 3185.292845] pl2303 ttyUSB0: pl2303 converter now disconnected from ttyUSB0
[ 3185.292876] pl2303 2-1:1.0: device disconnected
[ 3188.030058] usb 2-1: new full speed USB device using uhci_hcd and address 3
[ 3188.199935] pl2303 2-1:1.0: pl2303 converter detected
[ 3188.211968] usb 2-1: pl2303 converter now attached to ttyUSB0
[ 3811.411528] CE: hpet increased min_delta_ns to 7500 nsec
[ 4077.042588] usb 2-1: USB disconnect, address 3
[ 4077.042820] pl2303 ttyUSB0: pl2303 converter now disconnected from ttyUSB0
[ 4077.042848] pl2303 2-1:1.0: device disconnected
[ 4078.260089] hub 2-0:1.0: unable to enumerate USB device on port 1
[ 4079.330051] usb 2-1: new full speed USB device using uhci_hcd and address 5
[ 4079.500810] pl2303 2-1:1.0: pl2303 converter detected
[ 4079.513831] usb 2-1: pl2303 converter now attached to ttyUSB0