[ 3.156680] Bluetooth: BNEP (Ethernet Emulation) ver 1.3 [ 3.156683] Bluetooth: BNEP filters: protocol multicast [ 3.164397] Bridge firewalling registered [ 3.171572] Bluetooth: SCO (Voice Link) ver 0.6 [ 3.171575] Bluetooth: SCO socket layer initialized [ 3.177852] ppdev: user-space parallel port driver [ 3.449810] Bluetooth: RFCOMM TTY layer initialized [ 3.449820] Bluetooth: RFCOMM socket layer initialized [ 3.449822] Bluetooth: RFCOMM ver 1.11 [ 4.222144] ata1.00: disabled [ 5.262572] usbcore: deregistering interface driver btusb [ 5.290115] usb 7-1: USB disconnect, address 2 [ 6.986328] usb-storage: device scan complete [ 6.990544] scsi 5:0:0:0: Direct-Access Sony USB HS-CARD 4.82 PQ: 0 ANSI: 0 [ 6.992666] sd 5:0:0:0: Attached scsi generic sg0 type 0 [ 7.000387] sd 5:0:0:0: [sdb] Attached SCSI removable disk [ 22.979895] ADDRCONF(NETDEV_UP): wlan0: link is not ready [ 23.008491] sky2 eth0: enabling interface [ 23.009850] ADDRCONF(NETDEV_UP): eth0: link is not ready [ 31.625728] wlan0: deauthenticating from 00:0e:83:cb:f8:e1 by local choice (reason=3) [ 31.625785] wlan0: authenticate with 00:0e:83:cb:f8:e1 (try 1) [ 31.628306] wlan0: authenticated [ 31.628328] wlan0: associate with 00:0e:83:cb:f8:e1 (try 1) [ 31.631585] wlan0: RX AssocResp from 00:0e:83:cb:f8:e1 (capab=0x31 status=0 aid=35) [ 31.631588] wlan0: associated [ 31.652449] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready [ 31.652521] cfg80211: Calling CRDA for country: GB [ 31.654761] cfg80211: Received country IE: [ 31.654763] cfg80211: Regulatory domain: GB [ 31.654765] (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 31.654768] (2402000 KHz - 2482000 KHz @ 40000 KHz), (10000 mBi, 2300 mBm) [ 31.654769] cfg80211: CRDA thinks this should applied: [ 31.654771] cfg80211: Regulatory domain: GB [ 31.654772] (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 31.654774] (2402000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm) [ 31.654776] (5170000 KHz - 5250000 KHz @ 40000 KHz), (N/A, 2000 mBm) [ 31.654778] (5250000 KHz - 5330000 KHz @ 40000 KHz), (N/A, 2000 mBm) [ 31.654780] (5490000 KHz - 5710000 KHz @ 40000 KHz), (N/A, 2700 mBm) [ 31.654782] cfg80211: We intersect both of these and get: [ 31.654783] cfg80211: Regulatory domain: 98 [ 31.654784] (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 31.654786] (2402000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm) [ 31.654791] cfg80211: Leaving channel 5180 MHz intact on phy0 - no rule found in band on Country IE [ 31.654793] cfg80211: Leaving channel 5200 MHz intact on phy0 - no rule found in band on Country IE [ 31.654795] cfg80211: Leaving channel 5220 MHz intact on phy0 - no rule found in band on Country IE [ 31.654797] cfg80211: Leaving channel 5240 MHz intact on phy0 - no rule found in band on Country IE [ 31.654799] cfg80211: Leaving channel 5260 MHz intact on phy0 - no rule found in band on Country IE [ 31.654801] cfg80211: Leaving channel 5280 MHz intact on phy0 - no rule found in band on Country IE [ 31.654803] cfg80211: Leaving channel 5300 MHz intact on phy0 - no rule found in band on Country IE [ 31.654806] cfg80211: Leaving channel 5320 MHz intact on phy0 - no rule found in band on Country IE [ 31.654808] cfg80211: Leaving channel 5745 MHz intact on phy0 - no rule found in band on Country IE [ 31.654810] cfg80211: Leaving channel 5765 MHz intact on phy0 - no rule found in band on Country IE [ 31.654812] cfg80211: Leaving channel 5785 MHz intact on phy0 - no rule found in band on Country IE [ 31.654814] cfg80211: Leaving channel 5805 MHz intact on phy0 - no rule found in band on Country IE [ 31.654816] cfg80211: Leaving channel 5825 MHz intact on phy0 - no rule found in band on Country IE [ 31.654819] cfg80211: Current regulatory domain updated by AP to: GB [ 31.654820] (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 31.654822] (2402000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm) [ 32.766265] Intel AES-NI instructions are not detected. [ 32.793693] padlock: VIA PadLock not detected. [ 124.201054] tpm_tis 00:09: tpm_transmit: tpm_send: error -62