[   14.562538] svc: failed to register lockdv1 RPC service (errno 97).
[   14.563247] NFSD: Using /var/lib/nfs/v4recovery as the NFSv4 state recovery directory
[   14.571789] NFSD: starting 90-second grace period
[   14.672623] vboxdrv: Trying to deactivate the NMI watchdog permanently...
[   14.672626] vboxdrv: Successfully done.
[   14.672628] vboxdrv: Found 2 processor cores.
[   14.672732] VBoxDrv: dbg - g_abExecMemory=ffffffffa0ecda20
[   14.672751] vboxdrv: fAsync=0 offMin=0x13f offMax=0x1c3b
[   14.673326] vboxdrv: TSC mode is 'synchronous', kernel timer mode is 'normal'.
[   14.673328] vboxdrv: Successfully loaded version 3.1.8 (interface 0x00100001).
[   15.747083] tg3: eth0: Link is up at 100 Mbps, full duplex.
[   15.747085] tg3: eth0: Flow control is on for TX and on for RX.
[   15.747496] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   16.077477] Bluetooth: L2CAP ver 2.14
[   16.077479] Bluetooth: L2CAP socket layer initialized
[   16.084189] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[   16.084192] Bluetooth: BNEP filters: protocol multicast
[   16.097470] Bridge firewalling registered
[   16.104527] Bluetooth: SCO (Voice Link) ver 0.6
[   16.104529] Bluetooth: SCO socket layer initialized
[   16.212752] saa7134[0]/irq[10,4294938917]: r=0x20 s=0x00 PE
[   16.212755] saa7134[0]/irq: looping -- clearing PE (parity error!) enable bit
[   16.398188] Bluetooth: RFCOMM TTY layer initialized
[   16.398192] Bluetooth: RFCOMM socket layer initialized
[   16.398194] Bluetooth: RFCOMM ver 1.11
[   26.280059] eth0: no IPv6 routers present
[   96.098701] Bluetooth: HIDP (Human Interface Emulation) ver 1.2
[  102.662141] wlan0: deauthenticating from 00:1f:3f:0f:f8:b1 by local choice (reason=3)
[  102.662169] wlan0: direct probe to AP 00:1f:3f:0f:f8:b1 (try 1)
[  102.667841] wlan0: direct probe responded
[  102.667846] wlan0: authenticate with AP 00:1f:3f:0f:f8:b1 (try 1)
[  102.672913] wlan0: authenticated
[  102.672944] wlan0: associate with AP 00:1f:3f:0f:f8:b1 (try 1)
[  102.678220] wlan0: RX AssocResp from 00:1f:3f:0f:f8:b1 (capab=0x431 status=0 aid=1)
[  102.678224] wlan0: associated
[  102.695171] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[  104.041642] Intel AES-NI instructions are not detected.
[  104.107482] padlock: VIA PadLock not detected.
[  112.750203] wlan0: no IPv6 routers present
[  236.950056] CE: hpet increasing min_delta_ns to 15000 nsec
[  380.974909] CE: hpet increasing min_delta_ns to 22500 nsec
[  409.969526] warning: `VirtualBox' uses 32-bit capabilities (legacy support in use)
[  412.882376] device eth0 entered promiscuous mode
[  639.842585] CE: hpet increasing min_delta_ns to 33750 nsec
[ 2160.674715] device eth0 left promiscuous mode
[ 2202.237003] device eth0 entered promiscuous mode
[ 2321.800788] usb 2-2: new high speed USB device using ehci_hcd and address 3
[ 2321.951963] usb 2-2: configuration #1 chosen from 1 choice
[ 2322.003245] Initializing USB Mass Storage driver...
[ 2322.003903] scsi5 : SCSI emulation for USB Mass Storage devices
[ 2322.004059] usb-storage: device found at 3
[ 2322.004061] usb-storage: waiting for device to settle before scanning
[ 2322.004070] usbcore: registered new interface driver usb-storage
[ 2322.004100] USB Mass Storage support registered.
[ 2327.003057] usb-storage: device scan complete
[ 2327.003769] scsi 5:0:0:0: Direct-Access     SanDisk  Cruzer Micro     8.02 PQ: 0 ANSI: 0 CCS
[ 2327.004821] sd 5:0:0:0: Attached scsi generic sg2 type 0
[ 2327.014111] sd 5:0:0:0: [sdb] 15695871 512-byte logical blocks: (8.03 GB/7.48 GiB)
[ 2327.014811] sd 5:0:0:0: [sdb] Write Protect is off
[ 2327.014819] sd 5:0:0:0: [sdb] Mode Sense: 45 00 00 08
[ 2327.014825] sd 5:0:0:0: [sdb] Assuming drive cache: write through
[ 2327.018811] sd 5:0:0:0: [sdb] Assuming drive cache: write through
[ 2327.018822]  sdb: sdb1
[ 2327.025806] sd 5:0:0:0: [sdb] Assuming drive cache: write through
[ 2327.025817] sd 5:0:0:0: [sdb] Attached SCSI removable disk